InFocus IN12 manual To replace the lamp, Loosen the three screws indicated by an S mark

Page 29

To replace the lamp

Important!

When replacing the lamp, use the special screwdriver that comes with the SP-LAMP-029 replacement lamp. The projector does not come with a screwdriver.

1 Turn off the projector and unplug its AC power cord.

2 Wait for about 60 minutes to allow the projector’s current lamp to cool down completely.

3 Turn over the projector and place it on top of a desk or on some other stable surface.

4 Loosen the lamp cover screw, and then remove the lamp cover.

Lamp cover

5 Loosen the three screws indicated by an S mark.

Lamp cartridge

28

Image 29

Contents Page Contents Focus S, Focus T About this manualEnter To adjust image brightness Adjusting Image BrightnessOperation During Projection Image Operations During ProjectionZooming an Image Selecting the Color ModeTo change the color mode Freezing an Image Momentarily Cutting Off the Input Source ImageTo freeze the projected image Press the Blank keyTo display a pointer in the image Displaying a Pointer in the Projected ImageTo select the pointer type To clear the pointer from the imageChanging the aspect ratio of the projected image Eco ModeTo turn the Eco Mode on or off Turn the Eco Mode on or off Using the Func KeyAdjust image brightness Basic Setup Menu Operations Configuring Advanced Projector SettingsDisplaying the Setup Menu Configuring Setup Menu SettingsTo configure the Image Adjustment J Color Mode setting Basic Setup Menu ExampleTo configure the Image Adjustment J Contrast setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu Still Image RCVNormal About the Signal Specific Setting Unit Screen Settings Main MenuRcvun 169None LogoBlue BlackBlank Screen Auto Input Settings Main MenuComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Spot 1 / Spot Option Settings 2 Main MenuArrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / Oval Operational Info Main Menu RCV N Restore All Defaults Main MenuCleaning the Projector User MaintenanceCleaning the Projector Exterior Cleaning the LensTo check the current lamp use time Replacing the LampReplacing the Lamp When to replace the lampLoosen the three screws indicated by an S mark To replace the lampResetting the Lamp Time To reset the lamp time after exceeding the lamp life To reset the lamp timeAppendix Remote Controller Signal RangeConnecting to a Component Video Output Device Full-screen Display of an RGB Image Input Signal Example Projected ImageReattaching the Lens Cover