InFocus IN12 manual To configure the Option Settings 1 J Eco Mode setting

Page 12

To configure the “Option Settings 1 J Eco Mode” setting

1

2

3

4

Press the [ESC] key.

Press the [T] key three times to select “Option Settings 1”. Press the [ENTER] key.

Press the [T] key three times to select “Eco Mode”.

5

Use the [W] and [X] keys to select “On” or “Off”.

6

After you are finished, press the [MENU] key to exit the setup menu.

11

Image 12
Contents Page Contents About this manual EnterFocus S, Focus T Adjusting Image Brightness To adjust image brightnessOperation During Projection Image Operations During ProjectionSelecting the Color Mode To change the color modeZooming an Image Momentarily Cutting Off the Input Source Image Freezing an ImageTo freeze the projected image Press the Blank keyDisplaying a Pointer in the Projected Image To display a pointer in the imageTo select the pointer type To clear the pointer from the imageEco Mode To turn the Eco Mode on or offChanging the aspect ratio of the projected image Using the Func Key Adjust image brightnessTurn the Eco Mode on or off Configuring Advanced Projector Settings Basic Setup Menu OperationsDisplaying the Setup Menu Configuring Setup Menu SettingsBasic Setup Menu Example To configure the Image Adjustment J Contrast settingTo configure the Image Adjustment J Color Mode setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu RCV NormalStill Image Screen Settings Main Menu About the Signal Specific Setting UnitRcvun 169Logo NoneBlue BlackBlank Screen Input Settings Main Menu AutoComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Option Settings 2 Main Menu Arrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / OvalSpot 1 / Spot Operational Info Main Menu Restore All Defaults Main Menu RCV NUser Maintenance Cleaning the ProjectorCleaning the Projector Exterior Cleaning the LensReplacing the Lamp To check the current lamp use timeWhen to replace the lamp Replacing the LampTo replace the lamp Loosen the three screws indicated by an S markResetting the Lamp Time To reset the lamp time To reset the lamp time after exceeding the lamp lifeRemote Controller Signal Range AppendixConnecting to a Component Video Output Device Input Signal Example Projected Image Full-screen Display of an RGB ImageReattaching the Lens Cover