InFocus IN12 manual Appendix, Remote Controller Signal Range

Page 32

Appendix

Remote Controller Signal Range

When performing an operation on the remote controller, point it at the remote control signal receiver on the back or front of the projector. The following illustration shows the range of the remote controller signal.

±30 degrees

 

max.

±30 degrees

 

5 meters

max.

 

(16.4 feet) max.

5 meters

 

(16.4 feet) max.

Front

Back

5 degrees to

30 degrees

±30

degrees max.

5 meters

5 meters

(16.4 feet) max.

(16.4 feet) max.

Remote Controller Range

The allowable distance between the remote controller and the projector is less when there is a sharp angle between the remote controller and the remote control signal receiver.

Important!

To avoid running down the battery, store the remote control unit so its buttons are not pressed inadvertently.

31

Image 32
Contents Page Contents Focus S, Focus T About this manualEnter Adjusting Image Brightness To adjust image brightnessOperation During Projection Image Operations During ProjectionZooming an Image Selecting the Color ModeTo change the color mode Momentarily Cutting Off the Input Source Image Freezing an ImageTo freeze the projected image Press the Blank keyDisplaying a Pointer in the Projected Image To display a pointer in the imageTo select the pointer type To clear the pointer from the imageChanging the aspect ratio of the projected image Eco ModeTo turn the Eco Mode on or off Turn the Eco Mode on or off Using the Func KeyAdjust image brightness Configuring Advanced Projector Settings Basic Setup Menu OperationsDisplaying the Setup Menu Configuring Setup Menu SettingsTo configure the Image Adjustment J Color Mode setting Basic Setup Menu ExampleTo configure the Image Adjustment J Contrast setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu Still Image RCVNormal Screen Settings Main Menu About the Signal Specific Setting UnitRcvun 169Logo NoneBlue BlackBlank Screen Input Settings Main Menu AutoComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Spot 1 / Spot Option Settings 2 Main MenuArrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / Oval Operational Info Main Menu Restore All Defaults Main Menu RCV NUser Maintenance Cleaning the ProjectorCleaning the Projector Exterior Cleaning the LensReplacing the Lamp To check the current lamp use timeWhen to replace the lamp Replacing the LampTo replace the lamp Loosen the three screws indicated by an S markResetting the Lamp Time To reset the lamp time To reset the lamp time after exceeding the lamp lifeRemote Controller Signal Range AppendixConnecting to a Component Video Output Device Input Signal Example Projected Image Full-screen Display of an RGB ImageReattaching the Lens Cover