InFocus IN12 manual Using the Func Key, Adjust image brightness, Turn the Eco Mode on or off

Page 9

Using the [FUNC] Key

Pressing the [FUNC] key displays the menu shown below.

You can use this menu to perform the operations described below.

zAdjust image brightness

Highlight “Brightness” and then press the [ENTER] key.

This performs the same operation as pressing the [BRIGHT] key ( key) described on page 3.

zTurn the Eco Mode on or off

Highlight “Eco Mode” and then press the [ENTER] key.

This performs the same operation as pressing the [ECO] key (U key) described on page 7.

zSelect the aspect ratio of the projected image Highlight “Aspect Ratio” and then press the [ENTER] key.

This performs the same operation as pressing the [ASPECT] key (… key) described on page 7.

8

Image 9
Contents Page Contents About this manual EnterFocus S, Focus T To adjust image brightness Adjusting Image BrightnessOperation During Projection Image Operations During ProjectionSelecting the Color Mode To change the color modeZooming an Image Freezing an Image Momentarily Cutting Off the Input Source ImageTo freeze the projected image Press the Blank keyTo display a pointer in the image Displaying a Pointer in the Projected ImageTo select the pointer type To clear the pointer from the imageEco Mode To turn the Eco Mode on or offChanging the aspect ratio of the projected image Using the Func Key Adjust image brightnessTurn the Eco Mode on or off Basic Setup Menu Operations Configuring Advanced Projector SettingsDisplaying the Setup Menu Configuring Setup Menu SettingsBasic Setup Menu Example To configure the Image Adjustment J Contrast settingTo configure the Image Adjustment J Color Mode setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu RCV NormalStill Image About the Signal Specific Setting Unit Screen Settings Main MenuRcvun 169None LogoBlue BlackBlank Screen Auto Input Settings Main MenuComponent Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60Option Settings 1 Main Menu Setting Name Description Input Unit Option Settings 2 Main Menu Arrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / OvalSpot 1 / Spot Operational Info Main Menu RCV N Restore All Defaults Main MenuCleaning the Projector User MaintenanceCleaning the Projector Exterior Cleaning the LensTo check the current lamp use time Replacing the LampReplacing the Lamp When to replace the lampLoosen the three screws indicated by an S mark To replace the lampResetting the Lamp Time To reset the lamp time after exceeding the lamp life To reset the lamp timeAppendix Remote Controller Signal RangeConnecting to a Component Video Output Device Full-screen Display of an RGB Image Input Signal Example Projected ImageReattaching the Lens Cover