InFocus IN12 manual Reattaching the Lens Cover

Page 35

Reattaching the Lens Cover

Use the following procedure to replace the lens cover if it should accidentally become detached from the projector.

1 Insert the nub (‘) of the left tab of the lens cover into the depression () of the tab under the lens.

zWhen performing the above step, make sure that the lens cover is open to 90 degrees in relation to the front of the Data Projector.

2 Keeping the left nub (‘) in the left depression (), gently press the lens cover towards the right as you insert the nub (’) of the right lens cover tab into the depression () of the right tab under the lens.

zDo not apply undue force to the lens cover when performing the above step. Pressing too strongly can damage the tabs of the lens cover.

Press here with a pen or similarly pointed object as you slide the cover into place.

34

Image 35
Contents Page Contents Focus S, Focus T About this manualEnter Image Operations During Projection Adjusting Image BrightnessTo adjust image brightness Operation During ProjectionZooming an Image Selecting the Color ModeTo change the color mode Press the Blank key Momentarily Cutting Off the Input Source ImageFreezing an Image To freeze the projected imageTo clear the pointer from the image Displaying a Pointer in the Projected ImageTo display a pointer in the image To select the pointer typeChanging the aspect ratio of the projected image Eco ModeTo turn the Eco Mode on or off Turn the Eco Mode on or off Using the Func KeyAdjust image brightness Configuring Setup Menu Settings Configuring Advanced Projector SettingsBasic Setup Menu Operations Displaying the Setup MenuTo configure the Image Adjustment J Color Mode setting Basic Setup Menu ExampleTo configure the Image Adjustment J Contrast setting To configure the Option Settings 1 J Eco Mode setting Page Setup Menu Contents Image Adjustment Main Menu Still Image RCVNormal 169 Screen Settings Main MenuAbout the Signal Specific Setting Unit RcvunBlack LogoNone BlueBlank Screen Ntsc / NTSC4.43 / PAL / PAL-M / PAL-N / PAL60 Input Settings Main MenuAuto ComponentOption Settings 1 Main Menu Setting Name Description Input Unit Spot 1 / Spot Option Settings 2 Main MenuArrow 1* / Arrow 2 / Bar 1 / Bar 2 / Oval 1 / Oval Operational Info Main Menu RCV N Restore All Defaults Main MenuCleaning the Lens User MaintenanceCleaning the Projector Cleaning the Projector ExteriorTo check the current lamp use time Replacing the LampReplacing the Lamp When to replace the lampLoosen the three screws indicated by an S mark To replace the lampResetting the Lamp Time To reset the lamp time after exceeding the lamp life To reset the lamp timeAppendix Remote Controller Signal RangeConnecting to a Component Video Output Device Full-screen Display of an RGB Image Input Signal Example Projected ImageReattaching the Lens Cover