Meridian America D-ILA 1080MF1 Indicators, Standby Indicator, Operate Indicator, Lamp Button

Page 12

Indicators

STANDBY

A

OPERATE

B

LAMP

C

TEMP

D

FAN

E

HIDE

F

A Standby Indicator

Light on: Unit is in standby mode.

Blinking: Unit is cooling down.

B OPERATE Indicator

Light on: Illuminated when unit is currently operating (projecting).

C LAMP Button

Light on indicates that:

•the lamp needs to be replaced soon or immedi- ately;

•the lamp cover is removed;

•the lamp has failed and the unit is unable to project; or

•when the lamp fails during projection.

D TEMP Indicator

Light on: The internal temperature of the unit is abnormally high.

Blinking : The lamp needs to be replaced soon or immediately, or a failure has occurred in the unit.

E FAN Indicator

Light on : The internal fan has unintentionally stopped running.

Blinking : The lamp has reached the end of its life and it is time to replace the lamp, or a failure has occurred in this unit.

F HIDE Indicator

Light on : The video image has been temporar- ily cleared by pressing the HIDE button. Blinking : A fault has occurred.

12

Image 12

Contents ILA 1080MF1 For Customer use Safety precautions FCC Information U.S.A. onlyMachine Noise Information Germany only Product If in DOUBT, Consult a Competent Electrician Maintenance Procedures Information for Users on Disposal of Old Equipment EU OnlyEuropean Union Other Countries outside the European UnionPage Contents Accessories Controls & Features AC Power Input Socket Service ConnectorRear & Right Side Handling the Control Panel CoverRx/Tx Indicators Control PanelMenu Button Exit ButtonIndicators Standby IndicatorOperate Indicator Temp IndicatorIndicator Display Table Top panel indicatorsControl panel indicators Lamp replacementRemote Control Projector/Processor Select buttonsOn Button OFF ButtonTest Button main label Light ButtonZoom Tele/Wide Buttons main labels 8 Installing the Projector Projector and Screen Installation View from the sideView from Above Screen Size and Projection Distance Wide T TeleLens Shift Setting Adjust the projection screen positionRe-fit the lens shift cover Projection screen position image according to shift levelConnecting to Devices Connecting a Video ProcessorConnecting a computer or Home Automation System via RS232 Interfacing the ProjectorConnecting the Power Cable Supplied Adjusting zoom image size and focus Turning off the powerApply Mains Power Precautions During UseAdjustments and Settings Using Menus Menu StructureAccessing the Menus Press the Menu button After setting is completed, press the Exit buttonMenu Operation Buttons Pixel Adjust Setup Menu Menu PositionColor Temp Red, Green, BluePower Save Options Menu Menu DisplaySleep Time RC232C bpsWhen the lamp usage time reaches 2010 hours About Lamp ReplacementReplacing the Lamp Lamp Replacement Procedure Remove the control panel cover Loosen the screw and remove the lamp coverLoosen the screws on the lamp unit and lift up the handle Pull out the lamp unitTighten the screws of the lamp unit and fold down the handle Re-attach the lamp cover and fasten the screwCleaning and Replacing the Filter On-screen warning messages About warning indicators For NosTroubleshooting Power upInterface Sockets Pinouts RS-232C PortDVI-D Interface RS-232C External Control External control command table Numeric valueSpecial parameters Specifications Projector Dimensions All dimensions in millimetres