Meridian America D-ILA 1080MF1 operation manual Controls & Features

Page 9

Controls & Features

Front, top and underside

A

F

B

B

Underside

C D

E

G

H

G

A Indicator

Please refer to ‘Indicators’ (Page 12) for details.

B Air Inlets

(2 in front and 1 at bottom surface)

The air inlets absorb air to cool the interior of the unit. Do not block or allow warm air to blow into them. This may cause the unit to malfunction.

C Power Zoom Lens

1.9x ‘normal’ power zoom lens (model DILA1080MF1)

1.4x ‘short-throw’ power zoom lens (model DILA1080MF1S)

• Before projection, remove the lens cap.

D Remote Sensor (Front)

When operating with the remote control, aim it towards the sensor. (Also see page 14)

A remote sensor is also located on the rear of the unit.

E Lens Cap

Fit the cap on the lens when this unit is not in use.

F Lens Shift Cover

Remove this cover when using the Lens Shift feature for shifting the projecting position in the vertical direction.

G Foot

It is set at the lowest position when shipped from the factory. This unit does not come with a function to adjust the gradient.

H Filter

Cleans air drawn in from the air inlet. Please clean this filter regularly. (Page 30)



Image 9
Contents ILA 1080MF1 For Customer use Safety precautions FCC Information U.S.A. onlyMachine Noise Information Germany only Product If in DOUBT, Consult a Competent Electrician Information for Users on Disposal of Old Equipment EU Only Maintenance ProceduresEuropean Union Other Countries outside the European UnionPage Contents Accessories Controls & Features Service Connector AC Power Input SocketRear & Right Side Handling the Control Panel CoverControl Panel Rx/Tx IndicatorsMenu Button Exit ButtonStandby Indicator IndicatorsOperate Indicator Temp IndicatorTop panel indicators Indicator Display TableControl panel indicators Lamp replacementProjector/Processor Select buttons Remote ControlOn Button OFF ButtonTest Button main label Light ButtonZoom Tele/Wide Buttons main labels 8 Installing the Projector Projector and Screen Installation View from the sideView from Above Wide T Tele Screen Size and Projection DistanceAdjust the projection screen position Lens Shift SettingRe-fit the lens shift cover Projection screen position image according to shift levelConnecting a Video Processor Connecting to DevicesConnecting a computer or Home Automation System via RS232 Interfacing the ProjectorConnecting the Power Cable Supplied Turning off the power Adjusting zoom image size and focusApply Mains Power Precautions During UseMenu Structure Adjustments and Settings Using MenusAccessing the Menus Press the Menu button After setting is completed, press the Exit buttonMenu Operation Buttons Setup Menu Menu Position Pixel AdjustColor Temp Red, Green, BlueOptions Menu Menu Display Power SaveSleep Time RC232C bpsWhen the lamp usage time reaches 2010 hours About Lamp ReplacementReplacing the Lamp Loosen the screw and remove the lamp cover Lamp Replacement Procedure Remove the control panel coverLoosen the screws on the lamp unit and lift up the handle Pull out the lamp unitRe-attach the lamp cover and fasten the screw Tighten the screws of the lamp unit and fold down the handleCleaning and Replacing the Filter On-screen warning messages For Nos About warning indicatorsPower up TroubleshootingInterface Sockets Pinouts RS-232C PortDVI-D Interface RS-232C External Control External control command table Numeric valueSpecial parameters Specifications All dimensions in millimetres Projector Dimensions