Resetting Lamp Time
After installing a new lamp unit, the lamp time must be reset before the projector can be used. Resetting the lamp time resets the inter- nal counter to zero hours.
NOTE: if the previous lamp had accumulated over 2,000 hours of use, the projector will not operate until the lamp time has been reset.
1 Reconnect power to the projector
•The main power turns on and the Standby indi- cator on the unit lights up.
2 Point the remote control unit at one of the sensors on the projector. On the remote, press the EXIT, ENTER and HIDE buttons one after the other, then press and hold the DOWN button for 2 seconds or more
•The STANDBY and OPERATE indicators will blink alternately for a total of about 3 seconds. After blinking stops, lamp time resets and the unit re- turns to the standby mode (STANDBY indicator lights up). The lamp time counter has now been reset and a new count will start.
•If the accumulated lamp time has reached 2000 hours, the projector will not function (lamp will not light up) unless the lamp time is reset.
Check the lamp time has been reset
The lamp time can be checked via the ‘Lamp Time’ option on the ‘Information’ menu.
WARNING
Reset the lamp time only when you have replaced the lamp. Never reset it when the lamp is still in use. Otherwise, the approximate standard for gauging replacement time may be inaccurate, lamp performance may deteriorate and lamp blowout may occur.
Cleaning and Replacing the Filter
Clean the filter regularly. Otherwise, air intake efficiency may deteriorate and the projector may overheat. If the filter is extremely dirty and cannot be cleaned, or if it is damaged, replace the filter with a new one.
(inner filter: LC32058•002A).
Running the unit with a damaged filter (or without one at all) may allow dust to enter the projector and appear on the screen, preventing you from enjoying the video fully. If dirt has entered the unit or if you need information about the filter, please consult your authorised dealer.
1 Disconnect power from the projector
•Pull out the power plug from the connector on the rear of the unit while the Standby indicator is still on.
2 Remove the inner filter
•Push up and lift the clip at the base of the inner filter, and draw out the filter assembly.
Clip
Inner Filter
3 Clean the filter
•Clean the filter with water and dry it, avoiding direct sunlight. If it is extremely dirty, use a neu- tral detergent. Don’t scrape it or use a vacuum cleaner.
30