Turning off the power | Meridian America D-ILA 1080MF1 specification

Basic Operation

After installation, the projector will require initial set-up, adjustment, alignment and con- figuration (see next page). Once this has been done, the unit can be used simply by following these basic operational procedures.

2 Indicators

4 Adjusting zoom (image size) and focus

•These adjustments should normally be carried out as part of initial set-up. If the message ‘not available’ is displayed on-screen, these features have been locked out, and you will need to go to the Options menu to unlock them.

To enlarge the screen size, press the ZOOM T button (button 8 on the remote). To reduce the screen size, press the ZOOM W button (button 0 on the remote). Adjust the focus set- ting with the FOCUS +/- buttons (2 and 5 on the remote).

5 Hiding the image temporarily Press the HIDE button

RS232C Rx Tx

T			+

ZOOM			FOCUS

W			-

OPERATE

EXIT ON

OPERATE

OFF

HIDE

•The displayed image will disappear. Press the HIDE button again to restore the image.

6 Turning off the power

Press the OPERATE OFF button on the panel, or the OFF button on the remote, for 1 second or more

The OPERATE indicator turns off, the Standby indicator starts blinking and the projector switches to the cool down mode. The cool

1 Remove the lens cap

We recommend keeping the lens cap in place when the unit is not in use.

2 Apply Mains Power

On the application of power, the STANDBY indicator on the unit illuminates.

3 Press the OPERATE ON button for 1 second or more

•You can also press the ON button on the re- mote having previously pressed the DILA button

•Your video processor may be capable of turn- ing the projector on and off when required via RS232 command. Consult your dealer for more information.

The OPERATE indicator on the projector lights up and the projected image slowly appears.

•Upon projection, the image may flicker for a few seconds. This is not a fault.

•When the light source is turned on, the lamp will slowly become brighter. It will take more than a minute for the brightness to stabilize.

•When video sources employing copy-protection (HDCP) are in use, it may take a while for the image to appear, due to the projector and its source ‘handshaking’

down mode will last for about 60 seconds to allow the light source to cool off.

•The projector switches automatically into stand- by mode at the end of the cool down mode.

•The OPERATE OFF button will not work until about a minute has passed after the light source has been turned on. If necessary, wait for this to happen.

CAUTION: Do not pull out the plug when the Standby indicator is blinking. This may shorten the lamp life and cause a malfunction.

Precautions During Use

This unit makes use of a light source that reaches a high temperature during projection. Do not allow projection under the following conditions; doing so may cause fire or mal- function of the projector:

•Projection with the unit laid on its sides

•Projection with the unit installed in an un- reasonable angle. Avoid using this unit at an inclined angle. Doing so may cause unevenness in the colour or shorten the lamp life.

•Projection at a location that blocks the air inlets or exhaust vents (see page 16)

•Projection without removing the lens cap.