Meridian America D-ILA 1080MF1 Tighten the screws of the lamp unit and fold down the handle

Page 29

5 Slide in the new lamp unit until it is fully inserted

Handling the new Lamp Unit

Do not touch the glass surface of the lamp directly with your hand or stain it. Touching it with a bare hand may dirty the surface, hence shortening the lamp life, causing marked performance deterioration, image darkening, lamp blowout and other problems.

6 Tighten the screws of the lamp unit and fold down the handle

• Fasten the 2 screws with a ‘+’ screwdriver.

7 Re-attach the lamp cover and fasten the screw

• Fasten the screw with a ‘+’ screwdriver.

NOTE: When fitting the lamp cover, insert the left end (with 2 claws) of the lamp cover into the unit, followed by ensuring that the pro- truding part on the reverse side of the lamp cover fits snugly into the recess. As this protru- sion acts as a switch, misfitting may stop the projector from operating.

8 Re-attach the control panel cover

Handling the Control Panel Cover

•The gap between this unit and the control panel cover is narrow. Be careful not to trap your fin- ger in the gap between the projector body and the control panel cover.

•Be careful of the protrusions and corners of components to avoid injury.

•After attaching the control panel cover, check that the lock is fastened. The control panel cover may drop and cause injury.

Lamp Cover

Control Panel Cover

Fasten the lock on the control panel cover

29

Image 29

Contents ILA 1080MF1 For Customer use Machine Noise Information Germany only Safety precautionsFCC Information U.S.A. only Product If in DOUBT, Consult a Competent Electrician Information for Users on Disposal of Old Equipment EU Only Maintenance ProceduresEuropean Union Other Countries outside the European UnionPage Contents Accessories Controls & Features Service Connector AC Power Input SocketRear & Right Side Handling the Control Panel CoverControl Panel Rx/Tx IndicatorsMenu Button Exit ButtonStandby Indicator IndicatorsOperate Indicator Temp IndicatorTop panel indicators Indicator Display TableControl panel indicators Lamp replacementProjector/Processor Select buttons Remote ControlOn Button OFF ButtonZoom Tele/Wide Buttons main labels 8 Test Button main labelLight Button Installing the Projector View from Above Projector and Screen InstallationView from the side Wide T Tele Screen Size and Projection DistanceAdjust the projection screen position Lens Shift SettingRe-fit the lens shift cover Projection screen position image according to shift levelConnecting a Video Processor Connecting to DevicesConnecting a computer or Home Automation System via RS232 Interfacing the ProjectorConnecting the Power Cable Supplied Turning off the power Adjusting zoom image size and focusApply Mains Power Precautions During UseMenu Structure Adjustments and Settings Using MenusMenu Operation Buttons Accessing the Menus Press the Menu buttonAfter setting is completed, press the Exit button Setup Menu Menu Position Pixel AdjustColor Temp Red, Green, BlueOptions Menu Menu Display Power SaveSleep Time RC232C bpsReplacing the Lamp When the lamp usage time reaches 2010 hoursAbout Lamp Replacement Loosen the screw and remove the lamp cover Lamp Replacement Procedure Remove the control panel coverLoosen the screws on the lamp unit and lift up the handle Pull out the lamp unitRe-attach the lamp cover and fasten the screw Tighten the screws of the lamp unit and fold down the handleCleaning and Replacing the Filter On-screen warning messages For Nos About warning indicatorsPower up TroubleshootingDVI-D Interface Interface SocketsPinouts RS-232C Port RS-232C External Control Special parameters External control command tableNumeric value Specifications All dimensions in millimetres Projector Dimensions