Gateway 9250C manual Ping Results, Packets Sent, Packets Received, Percent Lost, RTT Min, RTT Max

Table 2-3Jetdirect sub-menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
	Ping Results		Use this item to view the ping test status and results
			using the control panel display. You can select the
			following items:
		Packets Sent	Shows the number of packets (0 - 65535) sent to the
			remote host since the most recent test was initiated or
			completed.
		Packets Received	Shows the number of packets (0 - 65535) received from
			the remote host since the most recent test was initiated
			or completed.
		Percent Lost	Shows the percent of ping test packets that were sent
			with no response from the remote host since the most
			recent test was initiated or completed.
		RTT Min	Shows the minimum detected roundtrip- time (RTT),
			from 0 to 4096 milliseconds, for packet transmission
			and response.
		RTT Max	Shows the maximum detected roundtrip- time (RTT),
			from 0 to 4096 milliseconds, for packet transmission
			and response.
		RTT Average	Shows the average round-trip-time (RTT), from 0 to
			4096 milliseconds, for packet transmission and
			response.
		Ping In Progress	Shows whether a ping test is in progress. Yes indicates
			a test in progress, and No indicates that a test
			completed or was not run.
		Refresh	When viewing the ping test results, this item updates
			the ping test data with current results. Select Yes to
			update the data, or No to maintain the existing data.
			However, a refresh automatically occurs when the
			menu times out or you manually return to the main
			menu.
Link Speed			The link speed and communication mode of the print
			server must match the network. The available settings
			depend on the device and installed print server. Select
			one of the following link configuration settings:
				CAUTION: If you change the link setting,
				network communications with the print server
				and network device might be lost.
			Auto (default): The print server uses auto-negotiation
			to configure itself with the highest link speed and
			communication mode allowed. If auto-negotiation fails,
			either 100TX HALF or 10TX HALF is set depending on
			the detected link speed of the hub/switch port. (A
			1000T half-duplex selection is not supported.)
			10T Half: 10 Mbps, half-duplex operation.
			10T Full: 10 Mbps, Full-duplex operation.
			100TX Half: 100 Mbps, half-duplex operation.
			100TX Full: 100 Mbps, full-duplex operation.

26 Chapter 2 Control panel ENWW