
Initial Setup menu
The Initial Setup menu contains the
●Networking and I/O menu
●
●Send Setup menu
NOTE: Values shown with "(default)" are the
Networking and I/O
Menu item | Values | Description | |
|
|
|
|
I/O Timeout | Select a value in the |
| range. The factory default |
| setting is 15 seconds. |
I/O timeout refers to the elapsed time before a job fails. If the stream of data that the device receives for a job gets interrupted, this setting indicates how long the device will wait before it reports that the job has failed.
Embedded Jetdirect | See Table |
|
|
EIO <X> Jetdirect |
|
|
|
Table 2-3 Jetdirect sub-menus
Menu item |
| Values and Description | |
|
|
|
|
TCP/IP | Enable |
| Off: Disable the TCP/IP protocol. |
|
|
| On (default): Enable the TCP/IP protocol. |
|
|
|
|
| Host Name |
| An alphanumeric string, up to 32 characters, used to |
|
|
| identify the device. This name is listed on the |
|
|
| HP Jetdirect configuration page. The default host name |
|
|
| is NPIxxxxxx, where xxxxxx is the last six digits of the |
|
|
| LAN hardware (MAC) address. |
|
|
|
|
| IPV4 Settings | Config Method | Specifies the method that TCP/IPv4 parameters will be |
|
|
| configured on the HP Jetdirect print server. |
|
|
| Bootp: Use BootP (Bootstrap Protocol) for automatic |
|
|
| configuration from a BootP server. |
|
|
| DHCP: Use DHCP (Dynamic Host Configuration |
|
|
| Protocol) for automatic configuration from a DHCPv4 |
|
|
| server. If selected and a DHCP lease exists, DHCP |
|
|
| Release and DHCP Renew menus are available to set |
|
|
| DHCP lease options. |
|
|
| Auto IP: Use automatic |
|
|
| address in the form 169.254.x.x is assigned |
|
|
| automatically. |
|
|
| Manual: Use the Manual Settings menu to configure |
|
|
| TCP/IPv4 parameters, such as an IPv4 address like |
|
|
| 123.123.123.123. |
|
|
|
|
ENWW | Initial Setup menu 21 |