Texas Instruments TMS320C6457 manual Hrdy Behavior During 16-Bit Multiplexed Write Operations

HPI Operation www.ti.com

3.9.2HRDY Behavior During 16-Bit Multiplexed Write Operations

Figure 15 shows an HPIC (HCNTL[1:0] = 00b) write cycle during 16-bit multiplexed HPI operation. An HPIC write cycle does not cause HRDY to go high.

Figure 15. HRDY Behavior During an HPIC Write Cycle in the 16-Bit Multiplexed Mode

HCS
HCNTL[1:0]	00	00
HR/W
HHWIL
Internal
HSTRB
HD[15:0]	1st halfword	2nd halfword
HRDY

Figure 16 includes a HPID write cycle without autoincrementing in the 16-bit multiplexed mode. The host writes the memory address while HCNTL[1:0] = 10b and writes the data while HCNTL[1:0] = 11b. During the HPID write cycle, HRDY goes high only for the second halfword access.

Figure 16. HRDY Behavior During a Data Write Operation in the 16-Bit Multiplexed Mode

(Case 1: No Autoincrementing)

HPIA write

HCS

HPID write

HCNTL[1:0] 10 10 11 11

HR/W

HHWIL

Internal

HSTRB

1st halfword 2nd halfword 1st halfword 2nd halfword

HD[15:0]

HRDY

Figure 17 shows autoincrement HPID write cycles in the 16-bit multiplexed mode when the write FIFO is empty prior to the HPIA write. The host writes the memory address while HCNTL[1:0] = 10b and writes the data while HCNTL[1:0] = 01b. HRDY does not go high during any of the HPID write cycles.

Figure 17. HRDY Behavior During a Data Write Operation in the 16-Bit Multiplexed Mode

(Case 2: Autoincrementing Selected, FIFO Empty Before Write)

HPIA write

HCS

HPID+ writes

HCNTL[1:0] 10 10 01 01 01 HR/W

HHWIL Internal

HSTRB

1st halfword 2nd halfword 1st halfword 2nd halfword 1st halfword

HD[15:0]

HRDY

Figure 18 shows a case similar to that of Figure 17. However, in Figure 18, the write FIFO is not empty when the HPIA access is made. HRDY goes high twice for the first halfword access of the HPIA write cycle. The first HRDY high period is due to the non-empty FIFO. The data currently in the FIFO must first be written to the memory. This results in HRDY going high immediately after the falling edge of the data strobe (HSTRB). The second and third HRDY high periods occur for the writes to the HPIA. HRDY remains low for the HPID accesses.

24 Host Port Interface (HPI) SPRUGK7A –March 2009 –Revised July 2010

Copyright © 2009–2010, Texas Instruments Incorporated