www.ti.com | MDIO Registers |
4.13 MDIO User Access Register 1 (USERACCESS1)
The MDIO user access register 1 (USERACCESS1) is shown in Figure 38 and described in Table 35.
Figure 38. MDIO User Access Register 1 (USERACCESS1)
31 | 30 | 29 | 28 | 26 | 25 | 21 | 20 | 16 |
GO | WRITE | ACK |
| Reserved | REGADR |
|
| PHYADR |
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
15 |
|
|
|
|
|
|
| 0 |
DATA
LEGEND: R = Read only; R/W = Read/Write; W1S = Write 1 to set, write of 0 has no effect;
Table 35. MDIO User Access Register 1 (USERACCESS1) Field Descriptions
Bit | Field | Value | Description |
|
|
|
|
31 | GO | Go bit. Writing 1 to this bit causes the MDIO state machine to perform an MDIO access when it is | |
|
|
| convenient for it to do so; this is not an instantaneous process. Writing 0 to this bit has no effect. |
|
|
| This bit is writeable only if the MDIO state machine is enabled. This bit will self clear when the |
|
|
| requested access has been completed. Any writes to the USERACCESS0 register are blocked |
|
|
| when the GO bit is 1. |
|
|
|
|
30 | WRITE |
| Write enable bit. Setting this bit to 1 causes the MDIO transaction to be a register write; otherwise, |
|
|
| it is a register read. |
|
| 0 | The user command is a read operation. |
|
| 1 | The user command is a write operation. |
|
|
|
|
29 | ACK | Acknowledge bit. This bit is set if the PHY acknowledged the read transaction. | |
|
|
|
|
Reserved | 0 | Reserved | |
|
|
|
|
REGADR | Register address bits. This field specifies the PHY register to be accessed for this transaction | ||
|
|
|
|
PHYADR | PHY address bits. This field specifies the PHY to be accessed for this transaction. | ||
|
|
|
|
DATA | User data bits. These bits specify the data value read from or to be written to the specified PHY | ||
|
|
| register. |
|
|
|
|
SPRUFI5B
Submit Documentation Feedback | (MDIO) |
|
©