www.ti.com
DDR2 Memory Controller Registers
4.4SDRAM Refresh Control Register (SDRFC)
The SDRAM refresh control register (SDRFC) is used to configure the DDR2 memory controller to:
∙Enter and Exit the
∙Meet the refresh requirement of the attached DDR2 device by programming the rate at which the DDR2 memory controller issues autorefresh commands.
The SDRFC is shown in Figure 23 and described in Table 21.
|
|
| Figure 23. SDRAM Refresh Control Register (SDRFC) |
31 | 30 | 29 | 16 |
SR | Rsvd |
| Reserved |
R/W- | R/W- |
| |
0x0 | 0x0 |
|
|
15 |
|
| 0 |
|
|
| REFRESH_RATE |
|
|
|
LEGEND: R/W = Read/Write; R = Read only;
Table 21. SDRAM Refresh Control Register (SDRFC) Field Descriptions
Bit | Field | Value | Description |
31 | SR |
| |
|
|
| Refresh mode and the DDR2 Memory Controller to enter the Self Refresh state. |
|
| 0 | Exit |
|
| 1 | Enter |
30 | Reserved |
| Reserved. Writes to this register must keep this field at its default value. |
Reserved |
| Reserved. The reserved bit location is always read as 0. A value written to this field has no effect. | |
REFRESH_RATE |
| Refresh rate bits. The value in this field is used to define the rate at which connected SDRAM | |
|
|
| devices will be refreshed as follows: effect. |
SDRAM refresh rate = DDR_CLK clock rate / REFRESH_RATE
Writing a value less than 0x0100 to this field will cause it to be loaded with 2 * T_RFC value from the SDRAM Timing 1 Register.
40 | DSP DDR2 Memory Controller | SPRUF85 |