Paxar 9860 manual Psk

PSK

(Pre-Shared Key)

Authentication mode of WPA used in SOHO environments. The key value (or pass-phrase) is used for network authentication only (not data encryption). It does not use a RADIUS server like the other modes, but uses a shared key to provide the initial authentication with the access point or host.

RADIUS (Remote	This is an authentication server, such as the Cisco® ACS,
Authentication	Microsoft® IAS, etc.
Dial-In Server)
RARP or	One of the available boot methods. The device sends an
Reverse Address	RARP request and the RARP server responds with an IP
Resolution	address. The device knows its MAC address and the server
Protocol	responds with the IP address for it.
Relative	The file or directory location on the user’s system relative to
Pathname	the user’s current location on the system (what directory the
	user is currently in). For example, mpcl toolbox\9855.phu
Router	Any device that forwards data along networks. Routers are
	located at gateways.
Shared	The access point sends an unencrypted challenge text string to
Authentication	any device attempting to communicate with it. The device
	requesting authentication encrypts the challenge text and
	sends it back to the access point. If the challenge text is
	encrypted correctly, the access point allows the requesting
	device to authenticate. Both the unencrypted challenge and
	the encrypted challenge can be monitored; however, this
	leaves the access point open to attack. Because of this
	weakness, shared key authentication can be less secure than
	open authentication.
Signal Strength	A percentage (1 to 100) of the connection between the device
	and access point. If the signal strength is 0, there is no
	connection with the access point; 30 or less indicates you may
	be experiencing interference or close to being out of access
	point range, and below 50, printing performance could be
	affected. To improve the signal strength, try moving the printer
	closer to the access point and away from other radio devices
	such as Bluetooth® wireless devices, microwave ovens, or 2.4-
	GHz cordless phones.
Speed or	Sets the maximum rate of communication between the devices
Transmit Rate	on the network. It is also called transmit rate. The speeds are
	in megabits per second (Mbps) and include: 1, 2, 5.5, 11, 12,
	18, 24, 36, 48, and 54.
SSID or	A unique identifier that must match for all nodes on a
Service Set	subnetwork to communicate with each other. It consists of up
Identifier	to 32 characters (any printable character, including spaces). If
	using the space character, it must be enclosed in quotation
	marks. It is case-sensitive.

G-4MonarchNet2 Operating Instructions