On-Q/Legrand 364732-01 owner manual Advanced Setup, Modify the Configuration Port

Page 17

V.Advanced Setup

A.Management

On this management screen (see Figure 12), you can

1.Change Administrator’s password: change the password for the device.

2.Limit Management: Enables two stations to manage this Router/Switch through Web configuration. Enter the MAC addresses of the stations you selected for management. After the setup is completed, only the assigned stations with correct password authentication can manage this device.

3.Block Internet Request: Blocks requests from Internet to the local network.

If this item is checked, the function of management through Web configuration will be disabled. In other words, Internet requests and the HTTP management, namely ICMP, IDENT, and HTTP will be rejected.

Management via Internet: Allows management of this device via HTTP from Internet.

4.Modify the Configuration Port.

 

 

 

Figure 12

 

 

 

 

Change Administrator’s password

 

New Password

Enter the new password.

 

Confirm New

Re-enter the new password for confirmation.

 

Password

 

 

 

 

 

 

 

 

 

Innovations in Home Living.

301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies, Inc All Rights Reserved.

Middletown, PA 17057

www.onqhome.com

(800)-321-2343

14

Page 16 Page 18
Image 17
Page 16 Page 18
Contents
Port ROUTER/SWITCH P/N CE Mark Warning FCC CertificationsTable of Contents Introduction Small Office/ Home Office SetupII. Product Overview Router/Switch 9VDC Power Supply P/NVDC Input Network Port Local Switch Ports Router/Switch Module Connection AreaSwitch Port LEDs WAN LED Status LED III. Installation Innovations in Home Living Not run PPPoE software on your computers Obtain configuration automaticallyDevice Information Adapter Address Static configuration is selectedUnless you are sure it is necessary to modify your MAC Address. To modify the addressAddress PPPoE DSL dynamic ModeCheck Modify and enter the desired MAC Input for this field is 32 alphanumeric charactersClick on Help connecting to certain web sites or speedingDevice will save Information, restart and return to the previous Not alter the content unless you are sure it is Static Mode Necessary to modify your MAC address. To modify You with the nameSave Undo Following field for you to enter the starting IP Check this radio button to enable this device toWins server Addresses. Click Back to return to the Local PortTo continue Change Administrator’s password Advanced SetupModify the Configuration Port Address with all F’s EnableBlock Internet ResultVirtual Server Undo ADD IP Range IP addressesIP addresses to filter/forward Direction ~From Local IP ~To Remote IPFilter List Displays all the Packet Filters Added filter will appear on the Filter ListClick to delete all the filters on the list Click on the Index drop-down menu to selectStatic Route To save the settings After completing the settings on this page, clickTo clear all the settings on this SaveUndo Save RELEASE/DISCONNECT Network Status Connection StatusInformation on the Internet Port RENEW/CONNECTRefresh Click this button to refresh the list To reset to factory default settings, click the GO button Others Factory Reset see FigureTo save the current configuration to file Save ConfigurationSettings Load Configuration From File File Path/NameUpgrade NOW Firmware Upgrade see FigureWhat is a DMZ? VI. TroubleshootingHow can I know if I am using PPPoE? What is PPPoE PPP over Ethernet ?What does the message IP address conflict mean? Check the status of this productIP Configuration Reply from 192.168.0.1 bytes=32 time=3ms TTL=100 Type ping 168.95.192.1 and click OKWAN NTP, HTTP, TftpAOE 2300-2400tcp 2300-2400udp 47624tcp VDO Live NoneAuthentication Chap Is now available Connecting to serverPassword AuthenticationCHAP failure Xxx Minutes Connection establish timeout
Top Page Image Contents