On-Q/Legrand 364732-01 owner manual Added filter will appear on the Filter List

Page 22

TCP/UDP Port Filter

Filter using the port number. You can set filter for a single port or a range of ports.

NOTE: Performing a Factory Reset will erase all previously entered device settings.

Filter/Forward

Select to Filter or Forward for the following

assigned port(s).

Single/Range

You can filter a single port, or a range of ports

Port Number

The port number(s) for the filters.

Port Type

TCP port: filter according to the Connection-

Based Application Service on the remote

server using the port number.

UDP port: filter according to the

Connectionless Application Service on the

remote server using the port number.

ADD

Each time you finish setting a filter, click the

ADD

button

and the added filter will appear on the Filter List

UNDO

Click

UNDO

to clear all the settings in this categrory

Filter List

Displays all the Packet Filters.

DELETE ALL

Click to delete all the filters on the list.

DELETE

Click on the Index drop-down menu to select the

desired filter number and then click

DELETE

to

delete only the selected filter.

Innovations in Home Living.

301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies, Inc All Rights Reserved.

Middletown, PA 17057

www.onqhome.com

(800)-321-2343

19

Image 22

Contents

Port ROUTER/SWITCH P/N FCC Certifications CE Mark WarningTable of Contents Small Office/ Home Office Setup IntroductionRouter/Switch 9VDC Power Supply P/N II. Product OverviewSwitch Port LEDs WAN LED Status LED Router/Switch Module Connection AreaVDC Input Network Port Local Switch Ports III. Installation Innovations in Home Living Obtain configuration automatically Not run PPPoE software on your computersUnless you are sure it is necessary to modify your MAC Static configuration is selectedDevice Information Adapter Address Address. To modify the addressCheck Modify and enter the desired MAC PPPoE DSL dynamic ModeAddress Input for this field is 32 alphanumeric charactersDevice will save Help connecting to certain web sites or speedingClick on Information, restart and return to the previousNecessary to modify your MAC address. To modify Static ModeNot alter the content unless you are sure it is You with the nameSave Undo Check this radio button to enable this device to Following field for you to enter the starting IPTo continue Addresses. Click Back to return to the Local PortWins server Modify the Configuration Port Advanced SetupChange Administrator’s password Block Internet Enable Address with all F’s ResultVirtual Server Undo ADD IP addresses to filter/forward IP addressesIP Range Direction ~From Local IP ~To Remote IPClick to delete all the filters on the list Added filter will appear on the Filter ListFilter List Displays all the Packet Filters Click on the Index drop-down menu to selectStatic Route To clear all the settings on this After completing the settings on this page, clickTo save the settings SaveUndo Save Information on the Internet Port Network Status Connection StatusRELEASE/DISCONNECT RENEW/CONNECTRefresh Click this button to refresh the list Others Factory Reset see Figure To reset to factory default settings, click the GO buttonSettings Save ConfigurationTo save the current configuration to file Load Configuration From File File Path/NameFirmware Upgrade see Figure Upgrade NOWVI. Troubleshooting What is a DMZ?What does the message IP address conflict mean? What is PPPoE PPP over Ethernet ?How can I know if I am using PPPoE? Check the status of this productIP Configuration Type ping 168.95.192.1 and click OK Reply from 192.168.0.1 bytes=32 time=3ms TTL=100AOE NTP, HTTP, TftpWAN 2300-2400tcp 2300-2400udp 47624tcp VDO Live NonePassword AuthenticationCHAP failure Is now available Connecting to serverAuthentication Chap Xxx Minutes Connection establish timeout