On-Q/Legrand 364732-01 Network Status Connection Status, Release/Disconnect, Renew/Connect

Page 26

F.Network Status

1.Connection Status

This screen (see Figure 18) displays the current Internet connection status. After the device is connected to the Internet Service, you will see IP, Subnet Mask, Gateway and DNS IP addresses on the table.

 

Figure 18

 

 

RELEASE/DISCONNECT

Click on this button to disconnect from ISP and release all the IP

 

information on the Internet Port.

RENEW/CONNECT

Click on this button to reconnect to the ISP and renew all IP information

 

on the Internet Port.

Innovations in Home Living.

301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies, Inc All Rights Reserved.

Middletown, PA 17057

www.onqhome.com

(800)-321-2343

23

Page 25 Page 27
Image 26
Page 25 Page 27
Contents
Port ROUTER/SWITCH P/N FCC Certifications CE Mark WarningTable of Contents Small Office/ Home Office Setup IntroductionRouter/Switch 9VDC Power Supply P/N II. Product OverviewVDC Input Network Port Local Switch Ports Router/Switch Module Connection AreaSwitch Port LEDs WAN LED Status LED III. Installation Innovations in Home Living Obtain configuration automatically Not run PPPoE software on your computersUnless you are sure it is necessary to modify your MAC Static configuration is selectedDevice Information Adapter Address Address. To modify the addressCheck Modify and enter the desired MAC PPPoE DSL dynamic ModeAddress Input for this field is 32 alphanumeric charactersDevice will save Help connecting to certain web sites or speedingClick on Information, restart and return to the previousNecessary to modify your MAC address. To modify Static ModeNot alter the content unless you are sure it is You with the nameSave Undo Check this radio button to enable this device to Following field for you to enter the starting IPWins server Addresses. Click Back to return to the Local PortTo continue Change Administrator’s password Advanced SetupModify the Configuration Port Block Internet EnableAddress with all F’s ResultVirtual Server Undo ADD IP addresses to filter/forward IP addressesIP Range Direction ~From Local IP ~To Remote IP Click to delete all the filters on the list Added filter will appear on the Filter List Filter List Displays all the Packet Filters Click on the Index drop-down menu to selectStatic Route To clear all the settings on this After completing the settings on this page, clickTo save the settings SaveUndo Save Information on the Internet Port Network Status Connection StatusRELEASE/DISCONNECT RENEW/CONNECTRefresh Click this button to refresh the list Others Factory Reset see Figure To reset to factory default settings, click the GO buttonSettings Save ConfigurationTo save the current configuration to file Load Configuration From File File Path/NameFirmware Upgrade see Figure Upgrade NOWVI. Troubleshooting What is a DMZ?What does the message IP address conflict mean? What is PPPoE PPP over Ethernet ?How can I know if I am using PPPoE? Check the status of this productIP Configuration Type ping 168.95.192.1 and click OK Reply from 192.168.0.1 bytes=32 time=3ms TTL=100AOE NTP, HTTP, TftpWAN 2300-2400tcp 2300-2400udp 47624tcp VDO Live NonePassword AuthenticationCHAP failure Is now available Connecting to serverAuthentication Chap Xxx Minutes Connection establish timeout
Top Page Image Contents