Refresh

On-Q/Legrand 364732-01 owner manual Refresh

Page 27

2.Sessions List

This screen (see Figure 19) displays active Internet sessions through this device.

	Figure 19

REFRESH	Click on this button to refresh the list and get the
	latest session list.
T/U	Displays TCP or UDP port type.
IP Client/ Port Client	The local network IP address/port number of one
	end point of the session.
Port Fake	An NAT feature where a Port Fake is used to
	translate the local network IP address for
	connecting to the Internet.
IP Remote/Port Remote	The outside network IP address/port number of the
	other end of the session.
Idle	The idle time of the session. If the idle time is too
	long (more than 15 minutes), the device will
	disconnect the idled session.

Innovations in Home Living.

Middletown, PA 17057

www.onqhome.com

(800)-321-2343

Image 27

Contents

Port ROUTER/SWITCH P/N CE Mark Warning FCC CertificationsTable of Contents Introduction Small Office/ Home Office SetupII. Product Overview Router/Switch 9VDC Power Supply P/NRouter/Switch Module Connection Area Switch Port LEDs WAN LED Status LEDVDC Input Network Port Local Switch Ports III. Installation Innovations in Home Living Not run PPPoE software on your computers Obtain configuration automaticallyAddress. To modify the address Static configuration is selectedDevice Information Adapter Address Unless you are sure it is necessary to modify your MACInput for this field is 32 alphanumeric characters PPPoE DSL dynamic ModeAddress Check Modify and enter the desired MACInformation, restart and return to the previous Help connecting to certain web sites or speedingClick on Device will saveYou with the name Static ModeNot alter the content unless you are sure it is Necessary to modify your MAC address. To modifySave Undo Following field for you to enter the starting IP Check this radio button to enable this device toAddresses. Click Back to return to the Local Port To continueWins server Advanced Setup Modify the Configuration PortChange Administrator’s password Result EnableAddress with all F’s Block InternetVirtual Server Undo ADD Direction ~From Local IP ~To Remote IP IP addressesIP Range IP addresses to filter/forwardClick on the Index drop-down menu to select Added filter will appear on the Filter ListFilter List Displays all the Packet Filters Click to delete all the filters on the list Static Route Save After completing the settings on this page, clickTo save the settings To clear all the settings on thisUndo Save RENEW/CONNECT Network Status Connection StatusRELEASE/DISCONNECT Information on the Internet PortRefresh Click this button to refresh the list To reset to factory default settings, click the GO button Others Factory Reset see FigureLoad Configuration From File File Path/Name Save ConfigurationTo save the current configuration to file SettingsUpgrade NOW Firmware Upgrade see FigureWhat is a DMZ? VI. TroubleshootingCheck the status of this product What is PPPoE PPP over Ethernet ?How can I know if I am using PPPoE? What does the message IP address conflict mean?IP Configuration Reply from 192.168.0.1 bytes=32 time=3ms TTL=100 Type ping 168.95.192.1 and click OK2300-2400tcp 2300-2400udp 47624tcp VDO Live None NTP, HTTP, TftpWAN AOEXxx Minutes Connection establish timeout Is now available Connecting to serverAuthentication Chap Password AuthenticationCHAP failure

On-Q/Legrand 364732-01 owner manual Refresh

disconnect the idled session.

Innovations in Home Living.