Multi-Tech Systems MT3334ZDXV Data Terminal Ready DTR Control, Load Factory Default Settings

MT3334ZDX/V Owner's Manual

Command:	&Dn	Data Terminal Ready (DTR) Control
Values:	n = 0, 1, 2, or 3
Default:	2
Description: &D0		Modem ignores the true status of the DTR signal
		and responds as if it is always on.
	&D1	When DTR drops while in online data mode, the
		modem enters command mode, issues an OK, and
		remains connected.
	&D2	When DTR drops while in online data mode, the
		modem hangs up.
	&D3	When DTR drops, the modem hangs up and resets
		as if an ATZ command were issued.
Command:	&Fn	Load Factory Default Settings
Values:	n = 0
Default:	None
Description:	&F0	Load factory settings as active configuration.
Command:	&Gn	V.22bis Guard Tone Control
Values:	n = 0, 1, or 2
Default:	0
Description: &G0		Disable guard tone.
	&G1	Enable 550 Hz guard tone.
	&G2	Enable 1800 Hz guard tone.
Command:	&Jn	Auxiliary Relay Control
Values:	n = 0
Default:	0
Description: &J0		The auxiliary relay is never closed.
	&J1	Not supported—responds ERROR.
Command:	&Kn	Flow Control Selection
Values:	n = 0, 3, or 4
Defaults:	3
Description: &K0		Flow control disabled.
	&K3	Enable CTS/RTS hardware flow control.
	&K4	Enable XON/XOFF software flow control.
Command:	&Mn	Communications Mode
Values:	n = 0
Defaults:	0
Description:	&M0	Asynchronous mode.

32