Multi-Tech Systems MT3334ZDXV owner manual Appendices

Page 59

Appendices

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that of which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom of each page or the first page of the transmission, the date and time it is sent and an identification of the business or other entity, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual. See the cover page of your fax software manual for setup details.

This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

59

Image 59
Contents Page Revision Description PatentsContents Index Telephone Line Introduction and Description RequirementsComputer Serial CableData Product FeaturesCommunications Software Voice Model MT3334ZDXV only Installation and ConnectionAbout this Manual FaxAppendices AT Commands, S-Registers and Result CodesTesting Your Modem Service, Warranty & Technical SupportInstallation Process Installation IntroductionSafety Warnings Page MultiModemZDX Connections Front Panel LED IndicatorsInstallation Is Your MultiModemZDX Ready for Use? Simple Operations Operating Your MultiModemZDXRemote Configuration AT&Fcr Software ConfigurationHardware/Software Confirmation MultiModemZDX Configuration ConfirmationNone of the LEDs Light When the Modem Is On TroubleshootingModem Does Not Respond to Commands Installation Modem Dials But Cannot Make Connection Installation Modem Disconnects While Online Modem Cannot Connect When AnsweringLosing Data Slow File TransferGarbage Characters on the Monitor AT Commands, S-Registers Result Codes Command Summary Dial string modifiers Echo Command Mode CharactersDial On-Hook/Off-Hook Control Monitor Speaker VolumeMonitor Speaker Mode Echo Online Data Characters= n Set Register Value Return Online to Data ModeEnable/Disable Result Codes Modulation HandshakeData Carrier Detect DCD Control Modem ResetResult Code Selection Long Space Disconnect22bis Guard Tone Control Load Factory Default SettingsCommunications Mode Data Terminal Ready DTR ControlATDS=n Data Compression Control \N n Error Correction Mode Selection\K n Set Break Control \V n Protocol Result CodeSerial Port Baud Rate Modem Baud RateRegisters S10 Register Unit Seconds Range 255 Default DescriptionS35 S11S28 S30S43 S37S42 S89 S48Terse Verbose Description DelayedLocal Analog Loopback Test Modem Testing Local Analog Loopback Test/V.54 LoopDigital Loopback Test/V.54 Loop 2 Local/Manual Digital Loopback Testlocal/manual Digital Loopback Test/V.54 Loop 2 Remote/AutoDigital Loopback Test remote/automatic Limited Warranty Recording Modem Information On-line Warranty RegistrationTech Support Service If you know the file name About the Multi-Tech BBS No Longer AvailableLogging on to the Multi-Tech BBS Downloading a FileIf you don’t know the file name Reading a MessageLeaving a Message Bulletins Multi-Tech Fax-Back Service No Longer AvailableAbout CompuServe/Internet No Longer Available Appendix a Technical Specifications Fax Modulation Intelligent FeaturesCommand Buffer Data ModulationHalf Duplex 2400 & 1200 bps22bis/V.22 Carrier Frequencies Fax 21 CH2Temperature Power Requirement ConnectorsDiagnostics IndicatorsAppendix B Tone Dial Frequencies 697 770 852 941Appendices MT3334ZDX, MT3334ZDXV Appendices Canadian Limitations Notice European Low Voltage Directive Compliance with Babt RequirementsPage Compliance with BS6328 Part Compliance with BS6789 .1 and PartAustralian and New Zealand Modem Warning Notice Modem CE Mark EMC and Safety ComplianceModem Commands Default Permissible Range Register Default Permissible RangeCall Attempts/Retries New Zealand Telecom Warning NoticeIndex Error Correction Page MT5634ZDXv Connections Power Supply Index