Lantronix 2100E manual Send the Escape Sequence +++ in Modem Mode, Show IP addr after Ring

	7: Setup Mode: Channel Configuration
	Table 7-8. Modem Mode Commands
Modem Mode Command	Function
ATDTx.x.x.x,pppp or	Makes a connection to an IP address (x.x.x.x) and a remote port number
ATDTx.x.x.x/pppp or	(pppp).
ATDTx.x.x.x:pppp
ATDTx.x.x.x	Makes a connection to an IP address (x.x.x.x) and the remote port
	number defined within the unit.
ATD0.0.0.0	Forces the unit into Monitor Mode if a remote IP address and port number
	are defined within the unit.
ATD or ATDT	Forces the unit into Monitor Mode if a remote IP address and port number
	are not defined within the unit.
ATDx.x.x.x	Makes a connection to an IP address (x.x.x.x) and the remote port
	number defined within the unit.
ATH	Hangs up the connection (Entered as +++ATH).
	Enables or disables connections from the network going to the serial port.
	n=0 disables the ability to make a connection from the network to the
ATS0=n	serial port.
	n=1-9 enables the ability to make a connection from the network to the
	serial port.
	n>1-9 is invalid.
	Enables or disables character echo and responses.
ATEn	n=0 disables character echo and responses.
	n=1 enables character echo and responses.
	Enables numeric response or full verbose.
ATVn	n=0 enables numeric response.
	n=1 enables full verbose.

Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V.

Send the Escape Sequence (+++) in Modem Mode

Send ‘+++’ in Modem Mode (Y) ? _

Disable or enable the WiBox 2100E’s ability to send the escape sequence. The default setting is Y (Yes) (send the escape sequence).

Show IP addr after 'RING'

Show IP addr after ‘RING’ <Y> ?

Disable or enable the WiBox 2100E's ability to show the IP address after RING in Modem Mode. The default is Y (Yes), to show the IP address.

WiBox® 2100E Device Server User Guide 58