Lantronix 2100E manual Monitor Mode, G0, G1, ....,Ge, Gf, S0, S1,...,Se, Sf

		9: Monitor Mode
Command	Command Name	Function
PI x.x.x.x	Ping	Pings unit with IP address x.x.x.x to check device
		status.
AT	ARP Table	Shows the unit’s ARP table entries.
TT	TCP Connection Table	Shows all incoming and outgoing TCP connections.
NC	Network Connection	Shows the unit’s current IP address, gateway,
		subnet mask, and DNS server.
RS	Reset	Resets the unit.
QU	Quit	Exits diagnostics mode.
G0, G1, ....,Ge, Gf	Get configuration from	Gets a memory page of configuration information
	memory page	from the device.
S0, S1,...,Se, Sf	Set configuration to memory	Sets a memory page of configuration information
	page	on the device.
GM	Get MAC address	Shows the unit's 6-byte MAC.
SS	Set Security record	Sets the Security record without the encryption key
		and length parameters. The entire record must still
		be written, but the encryption-specific bytes do not
		need to be provided (they can be null since they
		are not overwritten).
SA	Scan	Initiates a wireless scan if the wireless interface is
		enabled. Reports any stations found, including
		BSSID, SSID, and RSSI. If SA is followed by a
		string, the string is used to filter SSIDs before
		reporting. If the BSS does not broadcast its SSID,
		only the BSSID and RSSI are returned.
NS	Network Status	Reports the network interfaces’ statuses. Includes
		potentially negotiated parameters like speed/duplex
		for Ethernet or BSSID, encryption, authentication
		for wireless interfaces.
co	Set IP address, host bits,	Example:
	gateway , and DNS server	co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
	IP	with
		192.168.0.10 = IP address of the WiBox
		8 = number of host bits
		192.168.0.1 = gateway IP address
		10001 = port number of the WiBox
		192.168.1.10 = IP address of the DNS Server
		The WiBox stores the setup and performs a reset.
		It sends an X before the reset if the command was
		OK.
WS	Wireless Status	Displays wireless module status that includes
		packets received, transmitted, and dropped.

Responses to some of the commands are given in Intel Hex format.

WiBox® 2100E Device Server User Guide 76