Lantronix 2100E manual Wep, Display Current Key

			7: Setup Mode: Channel Configuration
	Security suite	0=none, 1=WEP, 2=WPA, 3=WPA2/802.11i (0) ? _
WEP
	Authentication: 0=open/none, 1=shared (1) ?
	Encryption: 1=WEP64, 2=WEP128 (2) ?
	Change Key (N) ? Y
	Display key (N) ?
	Key type 0=hex, 1=passphrase (0) ?			TX Key Index (1) ?
	Enter Key: **-**-**-**-**-**-**-**-**-**-**-**-**
	Authentication		Select whether the encryption keys are matched (1 = shared) with
			those of the communication partner before passing through messages
			or not (2 = open/none).
	Encryption		Length of the encryption key and the security strength. WEP64 uses a
			40 bits/5 bytes key (option 1). WEP128 uses a 104 bits/13 bytes key
			(option 2).
	Display Current Key		Select (Y) Yes to show the currently configured key/passphrase
	Change key		Select (Y) Yes to modify the currently configured key.
	Key type		Indicate whether the new key is in hexadecimal or passphrase format.
	Enter key		Enter the new encryption key. The passphrase input is not the same as
			ASCII input (as used on some products). ASCII is translated directly
			into hexadecimal bytes according to the ASCII table. The WiBox 2100E
			passphrase is hashed using the Neesus Datacom algorithm (for
			WEP64) or MD5 (for WEP128).
			The passphrase input is safer because it is up to 63 chars long. ASCII
			input is a maximum of 5 (WEP64) or 13 (WEP128) characters long and
			limits the number of key combinations.
			Please refer to the other equipment’s manual to determine the
			passphrase input style recommended.
			Note: Lantronix recommends using a passphrase of 20 characters or
			more for maximum security.
	TX Key index		Select the WEP key used for transmissions.

WPA

This firmware version allows only Pre-Shared Keys (PSK) for authentication.

Change key (N) ? Y

Display key (N) ?

Key type 0=hex, 1=passphrase (1) ? 1

Enter key: ***********************

Encryption: 0=TKIP, 1=TKIP+WEP (0) ?

Change key	Select (Y (Yes) to modify the currently configured key.
Display key	Select (Y) Yes at the prompt to show the currently configured
	key/passphrase
Key type	Indicate whether the new key is in hexadecimal or passphrase
	format.
Enter key	Enter the passphrase. The maximum length is 63 characters.
	Note: Lantronix recommends using a passphrase of 20
	characters or more for maximum security.

WiBox® 2100E Device Server User Guide 64