Lantronix 2100 manual Add ip address subnet mask, Remove ip address subnet mask

	5: Commands and Levels
add <ip address> <subnet mask>	Adds an entry to the IP filter table.
clrscrn	Clears the screen.
exit	Returns to the config level.
remove <ip address> <subnet mask>	Removes an entry from the IP filter table.
show	Displays the IP filter table.
show history	Displays the last 20 commands entered during the current
	CLI session.
write	Stores the current configuration in permanent memory.
line 1 (line:1) level commands
auto show statistics	Continuously displays line statistics.
baud rate <bits per second>	Sets the line speed.
clear line counters	Sets the serial counters to zero.
clrscrn	Clears the screen.
command mode always	Sets the current line to always be in command mode.
command mode echo serial string disable	Disables user-defined serial boot string to be echoed in
	the CLI.
command mode echo serial string enable	Enables user-defined serial boot string to be echoed in the
	CLI.
command mode serial string	Enables user to enter a custom string at boot time to enter
	command mode.
command mode serial string <string>	Sets a string that can be entered at boot time to enter
	command mode.
command mode serial string binary <string>	Sets a binary string that can be entered at boot time to
	enter command mode.
command mode signon message <string>	Sets an ASCII sign-on message that is sent from the seri-
	al port when the
command mode signon message binary <string>	Sets a binary sign-on message that is sent from the serial
	port when the
command mode wait time <milliseconds>	Sets boot-up wait time for command mode serial string.
data bits 7	Uses seven bits for data on the line.
data bits 8	Uses eight bits for data on the line.
default baud rate	Restores the default speed of 9600 bits per second.
default data bits	Restores the default of eight data bits.
default flow control	Restores the default of no flow control.
default interface	Restores the default interface type to this line.
default parity	Restores the default of no parity.
default protocol	Restores the default protocol on the line.
default stop bits	Restores the default of one stop bit.
default xoff char	Restores the default xoff character on this line.
default xon char	Restores the default xon character on this line.
exit	Exits to the enable level
flow control hardware	Uses hardware (RTS/CTS) flow control on the line.
flow control none	Does not provide flow control on the line.
flow control software	Uses software (xon/xoff characters) flow control on the
	line.
interface rs232	Sets the line interface to RS232.
interface rs485 full-duplex	Sets the line interface to RS485 in full-duplex mode.
interface rs485 half-duplex	Sets the line interface to RS485 in half-duplex mode.

IntelliBox-I/O 2100 Command Reference 69