Lantronix 2100 manual Link config-etherneteth0 level commands, Lpd lpd level commands

	5: Commands and Levels
protocol lpd or tunnel	Applies LPD or tunnel protocol on the line.
protocol modbus ascii	Applies Modbus ASCII protocol on the line.
protocol modbus rtu	Applies Modbus RTU protocol on the line.
protocol none	Uses no protocol on the line.
protocol tunnel	Applies tunnel protocol on the line.
reassert	Asserts line status with current configured values.
show	Displays the current status.
show command mode	Shows the command mode settings for the current line.
show history	Displays the last 20 commands entered during the current
	CLI session.
show line	Displays the current configuration.
show statistics	Shows the line statistics.
state disable	Disables the line so data cannot be sent/received.
state enable	Enables the line so data can be sent/received.
stop bits 1	Uses one stop bit after data on the line.
stop bits 2	Uses two stop bits after data on the line.
terminal <line>	Enters the configure-terminal level.
terminal network	Enters the configure-terminal level for the network.
termination disable	Refrains from terminating the line.
termination enable	Enables 120 ohm line termination in RS485 half-duplex
	mode.
tunnel <line>	Enters the tunnel level.
write	Stores the current configuration in permanent memory.
xoff char <control>	Sets the xoff character for use with software flow control
	on this line.
xon char <control>	Sets the xon character for use with software flow control
	on this line.
link (config-ethernet:eth0) level commands
clrscrn	Clears the screen.
default duplex	Restores the default duplex setting, which is auto.
default speed	Restores the default speed setting, which is auto-
	negotiate.
duplex auto	Sets duplex mode to auto.
duplex full	Sets duplex mode to full.
duplex half	Sets duplex mode to half.
exit	Exit back to interface configuration level
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current
	CLI session.
speed 10	Sets the speed of the Ethernet link to 10 Mbps.
speed 100	Sets the speed of the Ethernet link to 100 Mbps.
speed auto	Sets the speed of the Ethernet link to auto-negotiate.
write	Stores the current configuration in permanent memory.
lpd (lpd) level commands
auto show <line>	Continuously displays lpd status for the specified line.
clrscrn	Clears the screen.
exit	Exits to the enable level.

IntelliBox-I/O 2100 Command Reference 72