
| 5: Commands and Levels |
|
|
line <line> | Enters the line level. |
lpd <line> | Enters the configure lpd level. |
name <text> | Sets the name for this line. |
no clear line counters | Restores the serial counters to the aggregate values. |
no command mode | Disables command mode for the current line. |
no command mode serial string | Prevents the |
| used to enter |
no command mode signon message | Clears the signon message displayed at boot time and |
| when entering |
no name | Removes the name of this line. |
parity even | Uses a parity bit on the line for even parity. |
parity none | Does not use a parity bit on the line. |
parity odd | Uses a parity bit on the line for odd parity. |
protocol lpd | Applies Line Printer Daemon (LPD) protocol on the line. |
protocol lpd or tunnel | Applies LPD or tunnel protocol on the line. |
protocol modbus ascii | Applies Modbus ASCII protocol on the line. |
protocol modbus rtu | Applies Modbus RTU protocol on the line. |
protocol none | Uses no protocol on the line. |
protocol tunnel | Applies tunnel protocol on the line. |
reassert | Asserts line status with current configured values. |
show | Displays the current status. |
show command mode | Shows the command mode settings for the current line. |
show history | Displays the last 20 commands entered during the current |
| CLI session. |
show line | Displays the current configuration. |
show statistics | Shows the line statistics. |
state disable | Disables the line so data cannot be sent/received. |
state enable | Enables the line so data can be sent/received. |
stop bits 1 | Uses one stop bit after data on the line. |
stop bits 2 | Uses two stop bits after data on the line. |
terminal <line> | Enters the |
terminal network | Enters the |
termination disable | Refrains from terminating the line. |
termination enable | Enables 120 ohm line termination in RS485 |
| mode. |
tunnel <line> | Enters the tunnel level. |
write | Stores the current configuration in permanent memory. |
xoff char <control> | Sets the xoff character for use with software flow control |
| on this line. |
xon char <control> | Sets the xon character for use with software flow control |
| on this line. |
line 2 (line:2) level commands |
|
auto show statistics | Continuously displays line statistics. |
baud rate <bits per second> | Sets the line speed. |
clear line counters | Sets the serial counters to zero. |
clrscrn | Clears the screen. |
command mode always | Sets the current line to always be in command mode. |
70 |