HP B6960-90078 manual Command Line, 626

	Integrations with Other Applications
	Microsoft Cluster Server Integration
NOTE	When the command is run, the elapsed time for each backup
	specification is checked and the session is aborted if the specified
	conditions are met. For example, in the Data Protector GUI specify that
	the backup specification is aborted if it has been running for less than 30
	minutes. When the failover occurs and when the omniclus command is
	started, the session is aborted if it has been running for less than 30
	minutes, otherwise it continues.
	Temporarily Disabling Backup Sessions To balance the load after
	a failover, you can also disable the Cell Manager for some time. All
	running session are continuing but you cannot start new backups until
	the Cell Manager is enabled again. You define this only by using
	scripting.
Command Line	In the batch file, modify the omniclus command as follows:
	omniclus.exe -clus<Data Protector_virtual_server> -inhibit
	minutes
Examples	To disable new backups on the server obvs.company.com for 20 minutes,
	use the following command line:
	omniclus.exe -clus obvs.company.com -inhibit 20
	To disable new backups until the Cell Manager is enabled again, use the
	following command line:
	omniclus.exe -clus obvs.company.com -inhibit *
	To enable backups again, run the following command line in CLI:
	<Data_Protector_home>\bin\omniclus -clus obvs.company.com
	-inhibit 0

626 Chapter 13