ADIC/GRAU DAS and STK ACS Libraries

The STK ACS Library Device

Data Protector has to be installed and configured. See HP OpenView Storage Data Protector Installation and Licensing Guide.

The following information has to be obtained before you start installing the ACS Agent software:

The <hostname> of the host where ACSLS is running.

A list of ACS drive IDs that you want to use with Data Protector. To display the list, login on the host where ACSLS is running and execute the following command:

rlogin “ACSLS hostname” -l acssa

You will have to enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following command:

ACSSA> query drive all

The format specification of an ACS drive has to be the following:

ACS DRIVE: ID:#,#,#,# - (ACS num, LSM num, PANEL, DRIVE).

Make sure that the drives that will be used for Data Protector are in the state online. If a drive is not in the online state, change the state with the following command on ACSLS host:

vary drive <drive_id> online

A list of available ACS CAP IDs and ACS CAP format specification. To display the list, login on the host where ACSLS is running and execute the following command:

rlogin “ACSLS hostname” -l acssa

You will have to enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following command:

ACSSA> query cap all

The format specification of an ACS CAP has to be the following:

ACS CAP: ID:#,#,# (ACS num, LSM num, PANEL, DRIVE).

Make sure that the CAPs that will be used for Data Protector are in the state online and in manual operating mode.

If a CAP is not in the state online, change the state using the following command:

vary cap <cap_id> online

682

Chapter 14

Page 712
Image 712
HP B6960-90078 manual 682