HP B6960-90078 manual Eadr of a, Windows Client, 470

Disaster Recovery

Enhanced Automated Disaster Recovery of a Windows System

Recovery

You need the following to successfully perform a disaster recovery on the crashed system:

•A new hard disk to replace your crashed disk.

•A successful full client backup of the client that you want to recover.

•The Data Protector disaster recovery CD.

EADR of a	The following is a step-by-step procedure for performing EADR of a
Windows Client	Windows system:
	1. Boot from the disaster recovery CD of the original system.
	2.	Press F12 when the following message is displayed: To start
		recovery of the machine <HOSTNAME> press F12.
	3. Select the scope of recovery and press Enter. There are 5 different
		scopes of recovery:
		•	No recovery: Disaster recovery is not performed and the
			computer is rebooted.
		•	Default Recovery: Critical volumes are recovered. All other
			disks are not partitioned and formatted and are ready for Phase 3.
		•	Minimal Recovery: Only system and boot disks are recovered
			(available for EADR and OBDR only).
		•	Full Recovery: (For future releases).
		•	Full with Shared Volumes: Available for MSCS only. This
			option should be used if all nodes in the MSCS have crashed and
			you are performing Enhanced Automated Disaster Recovery of the
			first node. It will recover all volumes in the Restore Set including
			cluster shared volumes that were locked by the backed-up node at
			backup time.
			If at least one node is up and the MSCS service is running, than
			shared volumes will not be restored because the node keeps them
			locked. In this case, you should use Default Recovery.
	4. After you have selected the scope of the recovery, Data Protector
		starts setting up the DR OS directly to the hard disk. You can monitor
		the progress and, when the DR OS is set up, the system reboots.
	5.	Wait for 10 seconds when prompted To start recovery of the

470 Chapter 10