HP B6960-90078 manual Installing the ACS Media Agent on a 32-bit HP-UX System, 684

ADIC/GRAU DAS and STK ACS Libraries

The STK ACS Library Device

You should see the library drives with corresponding device files/SCSI addresses displayed in the list.

Installing the ACS Media Agent on a 32-bit HP-UX System

Prerequisites The following prerequisites for installation have to be met before installing the ACS Agent on an HP-UX system:

•The StorageTek library has to be configured and running. See the documentation that comes with the StorageTek library.

•Data Protector has to be installed and configured. See the HP OpenView Storage Data Protector Installation and Licensing Guide.

•The following information has to be obtained before you start installing the ACS Agent software:

✓The <hostname> of the host where ACSLS is running.

✓A list of ACS drive IDs that you want to use with Data Protector. To display the list, login on the host where ACSLS is running and execute the following command:

rlogin “ACSLS hostname” -l acssa

✓You will have to enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following command:

ACSSA> query drive all

The format specification of an ACS drive has to be the following:

ACS DRIVE: ID:#,#,#,# - (ACS num, LSM num, PANEL, DRIVE).

✓Make sure that the drives that will be used for Data Protector are in the state online. If a drive is not in the online state, change the state with the following command on ACSLS host:

vary drive <drive_id> online

✓A list of available ACS CAP IDs and ACS CAP format specification. To display the list, login on the host where ACSLS is running and execute the following command:

rlogin “ACSLS hostname” -l acssa

You will have to enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following command:

684 Chapter 14