HP B6960-90078 manual Prerequisites for Configuration, 628

Integrations with Other Applications

MC/ServiceGuard Integration

	— Package IP or virtual ip-address
	In addition, you will also need to create a volume group on a shared
	disk.
	• Ensure that the cluster nodes and the package IP are on the same
	subnet.
	• If you have DNS in your environment, ensure that all the cluster
	nodes and the package IP are registered with the DNS server.
Installation	Install all hosts in the cluster using the standard procedure for installing
	the Cell Manager on UNIX as described in the HP OpenView Storage
	Data Protector Installation and Licensing Guide.
IMPORTANT	If you need to add additional software components on cluster nodes using
	the GUI, make sure that the node to which you add the components is
	active.
	Prerequisites for Configuration
Configuration
	Before you start configuring Data Protector with MC/ServiceGuard,
	check the following:
	• The cluster should be installed and running.
	• Decide which systems are going to be the Primary Cell Manager and
	the Secondary Cell Manager(s).
	• Systems chosen to be the Primary Cell Manager and the Secondary
	Cell Manager(s) must have MC/ServiceGuard installed, with
	recommended patches, and must be configured as members of the
	same cluster. For instructions on MC/ServiceGuard installation and
	configuration, refer to the Managing MC/ServiceGuard manual.
	• Data Protector Cell Manager, with recommended patches, and all
	other Data Protector software components for the integrations you
	want to have in the cluster must be installed on the Primary node and
	each of the Secondary nodes. See the HP OpenView Storage Data
	Protector Installation and Licensing Guide for instructions.

628 Chapter 13