HP B6960-90078 manual Using Data Protector to Configure the STK ACS Library, 686

ADIC/GRAU DAS and STK ACS Libraries

The STK ACS Library Device

/<Data_Protector_home>/acs/ssi/ssi.sh start

<ACS_LS_hostname>

4.On UNIX ACS client, run the following command to check whether or not the library drives are properly connected to your system:

/opt/omni/lbin/devbra -dev

You should see the library drives with corresponding device files/SCSI addresses displayed in the list.

Using Data Protector to Configure the STK ACS Library

The direct library access configuration is the same as the ADIC/GRAU DAS library direct access configuration. Follow the GUI steps provided in the section “Using Data Protector to Configure the ADIC/GRAU Library and Drives” on page 671. Instead of choosing GRAU DAS Library as your device type, choose Storage Tek ACS Library.

Using Data Protector to Configure Drives

To configure drives in the STK ACS library, follow the same steps provided in the ADIC/GRAU DAS section “Using Data Protector to Configure Drives” on page 670.

Indirect Access to the Library: Installation and Configuration

This section focuses on the indirect access configuration.

Using Data Protector to Configure the STK ACS Library and Drives

The indirect access configuration steps are the same as the direct access configuration (see previous section for steps), except the default setting, Force Direct Library Access, should be turned off.

•Follow the same GUI steps as for the direct library access configuration. When the library configuration is complete, you will be prompted to create library drives.

686 Chapter 14