HP B6960-90078 manual 636

Integrations with Other Applications

MC/ServiceGuard Integration

IMPORTANT	The service name must be the same as that used in the configuration file.
	The service command (the SERVICE_CMD variable) must be the one used
	in the example below.
		For example:
		SERVICE_NAME [0] = omni_sv
		SERVICE_CMD [0] = “/etc/opt/omni/sg/csfailover.ksh start”
		SERVICE_RESTART [0] = “-r 2”
		To make sure that the Cell Manager package is restarted at
		failover, set the SERVICE_RESTART parameter to -R(to restart the
		service for an infinitive number of times; this is not recommended)
		or to “-r<number of restarts>” (to restart the service for
		defined number of times).
	9. Check and propagate the Data Protector cluster package files, with
	the following steps:
	a. Copy the package control file to other nodes within the cluster:
		remsh system2 “mkdir /etc/cmcluster/ob2cl”
		rcp /etc/cmcluster/ob2cl/ob2cl.cntl
		system2:/etc/cmcluster/ob2cl/ob2cl.cntl
	b. Enable the Data Protector shared disk as a cluster volume group
		(created before) on all cluster nodes:
		vgchange -c y /dev/vg_ob2cm
	c.	Check the Data Protector package:
		cmcheckconf -P /etc/cmcluster/ob2cl.conf
	d. If the check was successful, add the Data Protector package:
		cmapplyconf -P /etc/cmcluster/ob2cl.conf
	e.	Start the package:
		cmrunpkg ob2cl

The cluster should be configured and the Data Protector Cell

Manager package should be up and running.

636 Chapter 13