Toshiba VM4050 manual Using Your Phone’s Battery, Battery Capacity, Installingthe Battery

Using Your Phone’s Battery

Battery Capacity

Your PCS Phone is equipped with a Lithium Ion (LiIon) battery. It allows you to recharge your battery before it is fully drained.

The standard battery provides approximately 3.3 hours of continuous digital talk time (1.5 hours in analog) or approximately 360 hours of continuous digital standby time (18 hours in analog).

The extended battery provides approximately 5.4 hours of continuous digital talk time (2.4 hours in analog) or approximately 580 hours of continuous digital standby time (29 hours in analog).

When the battery charge is getting too low, the battery icon blinks. When there are approximately five minutes of talk time left, the phone sounds an audible alert and then powers down.

Note: Long backlight settings, searching for service, camera/camcorder mode, vibrate mode, and browser use affect the battery’s talk and standby times.

Tip: Be sure to watch your phone’s battery level indicator and charge the battery before it runs out of power.

Installingthe Battery

Your PCS Phone comes with a LiIon battery.

Follow these steps to install it:

1. Press and hold the latch on the phone and slide the battery cover to remove it.

2. Insert the bottom of the battery pack into the phone and place it down.

3. Place the battery cover on the phone and slide it until the latch snaps into place.

Note: Make sure the cover is securely attached to the phone. The battery pack may separate from the phone if the cover is not properly attached.

Section 2: Understanding Your PCS Phone

2A: Your PCS Phone – The Basics 13