Aiwa NSX-AJ22 manual Setting the Timer, Timer Recording, Adjust the volume, Prepare the source

Page 17

TIMER

SETTING THE TIMER

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

1Press one of the function buttons to select a source.

2Press TIMER repeatedly until 5 appears on the

display.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

3Within 6 seconds, turn MULTI JOG to designate

the timer-on time, then press ENTER or a.

Turning MULTI JOG changes both the hour and the minute. for gis also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly.

4Within 4 seconds, turn MULTI JOG to select the

duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5 minute steps.

f or g is also available in place of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or a is pressed within 4 seconds after step 4.

5 Adjust the volume.

RECORDING

6 Prepare the source.

 

The source sound will play at the volume level set in this step

 

 

when the power is turned on by the timer.

 

 

If the volume level is set to 17 or higher, however, it will

 

 

automatically be set to 16 when the power is turned on.

 

 

To listen to a CD, load the disc to be played first on tray 1.

 

 

To listen to a tape, insert the tape into deck 1 or 2.

 

 

To listen to the radio, select the band and tune in to a station.

TIMER

7 Press POWER to turn off the power.

 

When the timer-on time is reached, the unit turns on and

 

begins play with the selected source.

 

 

 

 

 

 

 

 

You can change the source that was selected in step 1 by pressing

 

one of the function buttons before pressing ENTER or ain step

 

3.

 

 

To check the timer setting

 

Press TIMER.

 

The timer-on time, the selected source, and the duration for the

 

timer-activated period will be displayed for 4 seconds.

 

To change any of the previous setting

 

Carry out from step 1.

 

However, if you do not change the timer-on time, in step 3 just

 

press ENTER twice and continue from step 4.

 

To cancel the timer standby mode temporarily

 

Press TIMER repeatedly so that 5 disappears.

 

To restore the timer standby mode, press again to display 5.

 

Using the unit while the timer is set

En

You can use the unit normally after setting the timer.

 

 

Before turning off the power, carry out step 5 and 6.

 

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press either TUNER BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until 5 REC appears on the

display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

•If the timer recording is done with the economizing mode (page 6) set to “ECO ON” or “ECO AUTO” and the power turns off, the dimmer mode will be set to “DIMMER 3” and the volume level will be 0 (minimum level) the next time the power is turned on.

•You cannot use the timer function to record from a CD or tape.

•You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or awithin 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting.

ENGLISH 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents
NSX-AJ22 Electric Power PrecautionsInstallation Table of Contents Connections Before connecting the AC cordConnect the right and left speakers to the main unit Connect the surround speakers to the main unitPositioning the Speakers Connecting AN Outdoor AntennaConnect the supplied antennas Connect the AC cord to an AC outletDimmer Mode Setting Power Economizing ModeBefore Operation Flash WindowSetting the Clock Remote ControlPress Clock while pressing Shift on the remote Control Press Enter or aVolume Audio AdjustmentsGraphic Equalizer Super T-BASS SystemPresetting Stations Manual TuningPreset Number Tuning RadioreceptionPlaying Discs Basic OperationsLoading Discs Playing Programmed PlayRandom /REPEAT Play To set the tape counter to When tapes are loaded in both decksTo select a playing deck Inserting Blank Spaces Basic Recording Insert the tape to be recorded on into deck Press w REC/REC Mute to start recordingPress Tape Deck 1/2 to select deck Dubbing a Tape ManuallyPress Sync DUB to start recording To stop dubbingInsert the tape into deck AI Edit RecordingPress w REC/REC Mute to start recording on First sideTo change the program of each side Repeat for the rest of the tracks for sideTimer Recording Setting the TimerAdjust the volume Press Power to turn off the powerSetting the Sleep Timer VIDEO/AUX Jacks Other Connections Other Features TimerCD Digital OUT Optical Jack Press VIDEO/AUXGeneral Care and MaintenanceTuner Section Cassette Deck SectionCopyright SpecificationsParts Index Advertencia PrecaucionesInstalació n Energía elé ctricaIndice Antes de conectar el cable de alimentació n de CA ConexionesImportante Terminal Surround Speakers R o LConexion DE UNA Antena Exterior Posicionamiento DE LOS Altavoces3Conecte las antenas suministradas Conecte el cable de CA a una toma de CAActivacion DEL Modo DE Ahorro DE Energia Antes DE LA OperacionModo DE Intensidad DE Iluminacio Ventanilla ParpadeantePulse Clock mientras pulsa Shift en el control Remoto Control RemotoPulse Enter o a PreparativosAjustes DE Audio Control DE VolumenEcualizador Grafico Sistema Super T-BASSPreajuste DE Emisoras Sintonizacion ManualSintonizacion Mediante Numero DE Preajuste Pulse fDOWN o gUP para seleccionar una EmisoraReproduccion DE Discos Operaciones BasicasIntroduccion DE Discos Pulse Disc Direct Play 1-3 para seleccionar Un disco Para seleccionar una platina de reproducció n Pulse Tape y z Push Eject para abrir el portacasetePara detener la reproducció n, pulse s Para poner el contador de cinta aGrabacion Reproduccion DE Cintas Grabacion BasicaInsercion DE Espacios SIN Grabar Pulse Tape Deck 1/2 para seleccionar la platina Copiado DE Toda LA CintaPulse Sync DUB para iniciar la grabació n Para detener el copiadoInserte la cinta en la platina Grabacion CON Edicion AIPara detener la grabació n Para borrar el programa de edició nPara cambiar el programa de cada cara Inserte la cinta en la platinaREC/REC Mute para iniciar la grabació n Grabacion CON Temporizador Ajuste DEL TemporizadorPara reiniciar el juego Para cancelar el temporizador para dormirPara disfrutar del juego Toma CD Digital OUT Optical Tomas VIDEO/AUXCaracteristicas Pulse VIDEO/AUXGeneralidades Cuidados Y MantenimientoSeccion DEL Sintonizador Seccion DE LA PlatinaDerechos DE Autor EspecificacionesEnergie é lectrique Signification des symboles graphiquesAvertissement Table DES Matieres Connecter les enceintes surround à l’appareil principal ConnexionsAvant de brancher le cordon secteur Surround Speaker R ou LConnexion D’UNE Antenne Exterieure Positionnement DES EnceintesConnecter les antennes fournies Brancher le cordon secteur à une prise de courantFenê TRE Clignotante Mise EN Service DU Mode Economie D’ENERGIEAvant L’UTILISATION Reglage DE L’HORLOGE TelecommandeAppuyer sur Enter ou a PreparationsEgaliseur Graphique Reglages AudioSysteme Super T-BASS Systeme BBEMemorisation DE Stations Accord ManuelAccord SUR UNE Station Memorisee Reception Radio SONLecture DE Disques Operations DE BaseMise EN Place DE Disques Shift Lecture ProgrammeeLecture ALEATOIRE/REPETEE Quand il y a une cassette dans chacune des deux platines Pour sé lectionner une platine de lecturePour mettre le compteur à Insertion D’ESPACES Blancs Enregistrement DE BaseInsé rer la cassette à enregistrer dans la platine Appuyer sur w REC/REC Mute pour dé marrer ’enregistrementPour arrê ter la duplication Appuyer sur Tape Deck 1/2 pour sé lectionner la PlatineAppuyer sur Sync DUB pour dé marrer l’enregistrement Programme du deuxiè me enregistrement Insé rer la cassette dans la platinePour arrê ter l’enregistrement Pour effacer le programme du montageFace Ré pé ter l’é tape 5 pour le reste des plages de la Face aPour dé marrer l’enregistrement Pour changer le programme de chaque faceAppuyer sur Power pour mettre l’appareil hors Tension Ré gler le volumeReglage DE LA Minuterie Pré parer la sourceUtilisation du jeu demo Pour annuler la minuterie d’arrê tPour ré initialiser le jeu demo Pour dé sactiver la dé monstration ou le jeu, appuyer sur aPrise CD Digital OUT Optical Prises VIDEO/AUXCaracteristiques Appuyer sur VIDEO/AUXGeneralites Soins ET EntretienPartie Tuner Partie MagnetocassetteDroits D’AUTEUR
Top Page Image Contents