EnGenius Technologies EOC5611P user manual Management → Snmp Settings

Page 55

8.3 Management → SNMP Settings

Click on the SNMP Settings link under the Management menu. This is a networking management protocol used to monitor network-attached devices. SNMP allows messages (called protocol data units) to be sent to various parts of a network. Upon receiving these messages, SNMP-compatible devices (called agents) return data stored in their Management Information Bases.

SNMP Enable/Disable

Select the Radio button to Enable or Disable SNMP function.

 

 

Contact

Specify the contact details of the device.

 

 

Location

Specify the location of the device.

 

 

Community Name

Specify the password for access the SNMP community for read only access.

 

 

Community Name

Specify the password for access the SNMP community for read and write access.

 

 

Trap Destination IP

Specify the IP address that will receive the SNMP trap.

Address

 

 

 

Trap Destination

Specify the password of the SNMP trap community.

Community Name

 

 

 

Apply / Cancel

Press Apply to apply the changes or Cancel to return previous settings.

 

 

54

Image 55
Contents EOC5611P Table of Contents Network Configuration Example Product Overview FeatureFully support all types of security types Wireless extensions to Ethernet networksWired LAN backup Training/Educational facilitiesBenefits System Requirement Package ContentsHardware Overview Red Bad Quality Access Point with WDS Function EOC5611P Multi-Function Instruction Guide Access PointWDS Bridge Client BridgeClient Router Computer Settings Assign a Static IP Logging Method Page Wireless Settings Access Point Mode → Wireless Network Station Separation Wireless SecuritySave / Cancel Suppressed SsidClient Bridge Mode → Wireless Network WDS Bridge Mode → Wireless Network MAC Address Client Router Mode → Wireless Network 1 WEP Wireless Security Settings3 WPA2-PSK WPA-PSKWPA-PSK Mixed Radius Secret 5 WPARadius Server Radius Port6 WPA2 WPA Mixed Radius Accounting Wireless → Wireless Advanced SettingsData Rate Transmit PowerProtection Mode Wireless Traffic ShapingAdd Wireless → Wireless MAC FilterACL Mode MAC Address FilterWireless → WDS Link Settings System → IP Settings LAN SettingsSystem → Spanning Tree Settings Router → WAN Settings Router SettingsWAN Settings → Static IP IP Subnet Mask Internet Connection TypeAccount Name Domain NamePage Get Automatically From WAN Settings → Dhcp Dynamic IPUse These DNS Servers Apply / Cancel Service Name WAN Settings → PPPoE Point-to-Point Protocol over EthernetLogin PasswordKeep Alive Connect on DemandWAN Settings → Pptp Point-to-Point Tunneling Protocol Username Pptp ServerRouter → LAN Settings IPSec Pass Through Router → VPN Pass ThroughPptp Pass Through L2TP Pass ThroughStarting Port Router → Port ForwardingAdd Entry ProtocolStatus → Main Information StatusPage Status → Wireless Client List Status → System Log Status → WDS Link Status Status → Connection Status Status → Dhcp Client Table Name Management SettingsManagement → Administration Confirm PasswordRemote Management Remote UpgradePort Management Vlan ID Management → Management VlanManagement → Snmp Settings Management → Backup/Restore Settings Management → Firmware Upgrade Manually Set Date Time Management → Time SettingsAutomatically Get Date Local Log Management → LogSyslog Log Server IP AddressManagement → Diagnostics Access Point Network Configuration ExampleWDS Bridge Mode Client Bridge ModeWDS Bridge Client Router Vlan Configuration Guide Page Page Page Federal Communication Commission Interference Statement Appendix a FCC Interference Statement