EnGenius Technologies EOC5611P user manual Package Contents, System Requirement, Hardware Overview

Page 7

1.3 Package Contents

Open the package carefully, and make sure that none of the items listed below are missing. Do not discard the packing materials, in case of return; the unit must be shipped in its original package.

1* Wireless Outdoor Access Point / Client Bridge (EOC5611P)

1* 24V/1A Power Adapter

1* Ethernet Cable

1* QIG

1* CD (User Manual)

2* 5dBi 5GHz Dipole Antennas

Auction: Using other Power Adapter than the one included with EOC5611P may cause damage of the device.

1.4 System Requirement

The following conditions are the minimum system requirement.

A computer with an Ethernet interface and operating under Windows XP, Vista, 7 or Linux.

Internet Browser that supports HTTP and JavaScript.

1.5Hardware Overview

Hardware Specification

MCU/RF	Atheros AR2313+AR5112

Memory	32MB SDRAM

Flash	8MB

Physical Interface	1 x 10/100 Fast Ethernet RJ-45
	1 x Reset Button
	1 x Antenna Switch ( Internal and External Switch )
	2 x SMA Connector ( One is for 2.4GHz and another is for 5GHz )
LED indicators	Power/ Status
	LAN (10/100Mbps)
	WLAN (Wireless is up)
	3 x Link Quality (Client Bridge mode)
	• Green: Good Quality
	• Yellow: Marginally Acceptable Quality

	6

Image 7

Contents EOC5611P Table of Contents Network Configuration Example Product Overview FeatureFully support all types of security types Wireless extensions to Ethernet networksWired LAN backup Training/Educational facilitiesBenefits System Requirement Package ContentsHardware Overview Red Bad Quality Access Point with WDS Function EOC5611P Multi-Function Instruction Guide Access PointWDS Bridge Client BridgeClient Router Computer Settings Assign a Static IP Logging Method Page Wireless Settings Access Point Mode → Wireless Network Station Separation Wireless SecuritySave / Cancel Suppressed SsidClient Bridge Mode → Wireless Network WDS Bridge Mode → Wireless Network MAC Address Client Router Mode → Wireless Network 1 WEP Wireless Security Settings3 WPA2-PSK WPA-PSKWPA-PSK Mixed Radius Secret 5 WPARadius Server Radius Port6 WPA2 WPA Mixed Radius Accounting Wireless → Wireless Advanced SettingsData Rate Transmit PowerProtection Mode Wireless Traffic ShapingAdd Wireless → Wireless MAC FilterACL Mode MAC Address FilterWireless → WDS Link Settings System → IP Settings LAN SettingsSystem → Spanning Tree Settings Router → WAN Settings Router SettingsWAN Settings → Static IP IP Subnet Mask Internet Connection TypeAccount Name Domain NamePage Get Automatically From WAN Settings → Dhcp Dynamic IPUse These DNS Servers Apply / Cancel Service Name WAN Settings → PPPoE Point-to-Point Protocol over EthernetLogin PasswordKeep Alive Connect on DemandWAN Settings → Pptp Point-to-Point Tunneling Protocol Username Pptp ServerRouter → LAN Settings IPSec Pass Through Router → VPN Pass ThroughPptp Pass Through L2TP Pass ThroughStarting Port Router → Port ForwardingAdd Entry ProtocolStatus → Main Information StatusPage Status → Wireless Client List Status → System Log Status → WDS Link Status Status → Connection Status Status → Dhcp Client Table Name Management SettingsManagement → Administration Confirm PasswordRemote Management Remote UpgradePort Management Vlan ID Management → Management VlanManagement → Snmp Settings Management → Backup/Restore Settings Management → Firmware Upgrade Manually Set Date Time Management → Time SettingsAutomatically Get Date Local Log Management → LogSyslog Log Server IP AddressManagement → Diagnostics Access Point Network Configuration ExampleWDS Bridge Mode Client Bridge ModeWDS Bridge Client Router Vlan Configuration Guide Page Page Page Federal Communication Commission Interference Statement Appendix a FCC Interference Statement