EnGenius Technologies EOC5611P user manual Client Bridge Mode, WDS Bridge Mode

Page 62

	to connect with or enter SSID manually.

Step3	Configure VLAN ID in your wireless device if available.

Step4	Select correct authentication type and password.

Auction: EOC5611P’s Access Point Mode does not provide DHCP server so the Wireless Client IP address must configure manually at the same subnet in Local Area Network.

9.2 Client Bridge Mode

Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP Router to join the network.

Please refer to the last section to check Access point’s configuration.

Client Bridge

Step1	Login to the web-based configuration interface with default IP 192.168.1.1

Step2	Select your country or region’s regulation.

Step3	Select Operation Mode to Client Bridge from System Properties.

Step4	802.11a/b/g wireless network.

Step5	Use site survey to scan Access Points that are available in nearby area.

Step6	Select the AP you would like to associate with.

Step7	Setup the authentication settings that match to the Access Point’s setting.

Step8	Press Apply to process all the configurations.

Auction: Client Bridge’s IP setting must match to the Access Point’s subnet.

9.3 WDS Bridge Mode

Use this feature to link multiple APs in a network. All clients associated with any APs can

communicate each other like an ad-hoc mode.

61

Image 62

Contents EOC5611P Table of Contents Network Configuration Example Feature Product OverviewTraining/Educational facilities Wireless extensions to Ethernet networksWired LAN backup Fully support all types of security typesBenefits Hardware Overview Package ContentsSystem Requirement Red Bad Quality EOC5611P Multi-Function Instruction Guide Access Point Access Point with WDS FunctionClient Bridge WDS BridgeClient Router Computer Settings Assign a Static IP Logging Method Page Wireless Settings Access Point Mode → Wireless Network Suppressed Ssid Wireless SecuritySave / Cancel Station SeparationClient Bridge Mode → Wireless Network WDS Bridge Mode → Wireless Network MAC Address Client Router Mode → Wireless Network Wireless Security Settings 1 WEPWPA-PSK 3 WPA2-PSKWPA-PSK Mixed Radius Port 5 WPARadius Server Radius Secret6 WPA2 WPA Mixed Wireless → Wireless Advanced Settings Radius AccountingWireless Traffic Shaping Transmit PowerProtection Mode Data RateMAC Address Filter Wireless → Wireless MAC FilterACL Mode AddWireless → WDS Link Settings LAN Settings System → IP SettingsSystem → Spanning Tree Settings WAN Settings → Static IP Router SettingsRouter → WAN Settings Domain Name Internet Connection TypeAccount Name IP Subnet MaskPage Use These DNS Servers WAN Settings → Dhcp Dynamic IPGet Automatically From Apply / Cancel Password WAN Settings → PPPoE Point-to-Point Protocol over EthernetLogin Service NameConnect on Demand Keep AliveWAN Settings → Pptp Point-to-Point Tunneling Protocol Pptp Server UsernameRouter → LAN Settings L2TP Pass Through Router → VPN Pass ThroughPptp Pass Through IPSec Pass ThroughProtocol Router → Port ForwardingAdd Entry Starting PortInformation Status Status → MainPage Status → Wireless Client List Status → System Log Status → WDS Link Status Status → Connection Status Status → Dhcp Client Table Confirm Password Management SettingsManagement → Administration NamePort Remote UpgradeRemote Management Management → Management Vlan Management Vlan IDManagement → Snmp Settings Management → Backup/Restore Settings Management → Firmware Upgrade Automatically Get Date Management → Time SettingsManually Set Date Time Log Server IP Address Management → Log Syslog Local LogManagement → Diagnostics Network Configuration Example Access PointClient Bridge Mode WDS Bridge ModeWDS Bridge Client Router Vlan Configuration Guide Page Page Page Appendix a FCC Interference Statement Federal Communication Commission Interference Statement