EnGenius Technologies EOC5611P user manual Connect on Demand, Keep Alive

Page 39

Connect on Demand

Select the Radio button to specify the maximum idle time. Internet connection will disconnect when it reach the maximum idle time, but it will automatically connect when user tries to access the network.

Keep Alive	Select the Radio button to keep internet connection always on. Specify the redial
	period once the internet lose connection.

Get Automatically From	Select the Radio button for get the DNS automatically from DHCP server.
ISP

Use These DNS Servers	Select the Radio button for setup the Primary DNS and Secondary DNS servers
	manually.

Discard Ping on WAN	Place a Check to Enable or Disable ping from WAN.

Apply / Cancel	Press Apply to apply the changes or Cancel to return previous settings.

Auction: If the router's MTU is set too high, packets will be fragmented downstream. If the router's MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may be unable to establish some connections. In either case, network performance can suffer.

38

Image 39

Contents EOC5611P Table of Contents Network Configuration Example Product Overview FeatureFully support all types of security types Wireless extensions to Ethernet networksWired LAN backup Training/Educational facilitiesBenefits Package Contents System RequirementHardware Overview Red Bad Quality Access Point with WDS Function EOC5611P Multi-Function Instruction Guide Access PointWDS Bridge Client BridgeClient Router Computer Settings Assign a Static IP Logging Method Page Wireless Settings Access Point Mode → Wireless Network Station Separation Wireless SecuritySave / Cancel Suppressed SsidClient Bridge Mode → Wireless Network WDS Bridge Mode → Wireless Network MAC Address Client Router Mode → Wireless Network 1 WEP Wireless Security Settings3 WPA2-PSK WPA-PSKWPA-PSK Mixed Radius Secret 5 WPARadius Server Radius Port6 WPA2 WPA Mixed Radius Accounting Wireless → Wireless Advanced SettingsData Rate Transmit PowerProtection Mode Wireless Traffic ShapingAdd Wireless → Wireless MAC FilterACL Mode MAC Address FilterWireless → WDS Link Settings System → IP Settings LAN SettingsSystem → Spanning Tree Settings Router Settings Router → WAN SettingsWAN Settings → Static IP IP Subnet Mask Internet Connection TypeAccount Name Domain NamePage WAN Settings → Dhcp Dynamic IP Get Automatically FromUse These DNS Servers Apply / Cancel Service Name WAN Settings → PPPoE Point-to-Point Protocol over EthernetLogin PasswordKeep Alive Connect on DemandWAN Settings → Pptp Point-to-Point Tunneling Protocol Username Pptp ServerRouter → LAN Settings IPSec Pass Through Router → VPN Pass ThroughPptp Pass Through L2TP Pass ThroughStarting Port Router → Port ForwardingAdd Entry ProtocolStatus → Main Information StatusPage Status → Wireless Client List Status → System Log Status → WDS Link Status Status → Connection Status Status → Dhcp Client Table Name Management SettingsManagement → Administration Confirm PasswordRemote Upgrade Remote ManagementPort Management Vlan ID Management → Management VlanManagement → Snmp Settings Management → Backup/Restore Settings Management → Firmware Upgrade Management → Time Settings Manually Set Date TimeAutomatically Get Date Local Log Management → LogSyslog Log Server IP AddressManagement → Diagnostics Access Point Network Configuration ExampleWDS Bridge Mode Client Bridge ModeWDS Bridge Client Router Vlan Configuration Guide Page Page Page Federal Communication Commission Interference Statement Appendix a FCC Interference Statement