Enterasys Networks 2200 manual Strain-Relief Bracket Screws

Installing the Device

Installation

Rack mounting the 2H258-17R involves the following:

•Attaching the strain-relief bracket

•Rack mounting the 2H258-17R (attaching the mounting brackets and fastening the device to the rack)

Attaching the Strain-Relief Bracket

Attach the strain-relief bracket to the 2H258-17R as follows:

1.Locate the strain-relief bracket and four 8-32 x 5/16-inch pan-headscrews in the rackmount kit.

CAUTION: Do not attempt to attach the strain-relief bracket with screws other than the 8-32 x 5/16-inch screws included with the 2H258-17R. Use of longer screws may damage the unit.

2.Place the 2H258-17R upside down (as shown in Figure 3-2) on a clean flat surface. Then attach the strain-relief bracket to the bottom of the 2H258-17R using the four 8-32 x 5/16-inch pan-head screws.

Figure 3-2 Attaching the Strain-Relief Bracket

Strain-Relief

Bracket Screws

Strain-Relief

Bracket

													CPU	COM	RESET	17R-2H258
													PWR
16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1
TX RX	TX RX	TX RX	TX RX	TX	RX TX RX	TX RX	TX RX	TX RX	TX RX	TX RX	TX RX	TX RX TX RX		TX RX	TX RX
													SWITCH WORKGROUP ETHERNET FAST

3068-03

Installation 3-5