Enterasys Networks 2200 manual Refer to the SmartSwitch Series 2E253

		Troubleshooting Checklist
Table 4-2 Troubleshooting Checklist (Continued)
Problem	Possible Cause	Recommended Action
No Local	Autobaud is enabled, but	Press ENTER (RETURN) (may take up to
Management	the baud rate has not yet	four times).
Password screen.	been detected.
	Terminal setup is not	Refer to the SmartSwitch Series 2E253,
	correct.	2H252, 2H253, and 2H258 Local
		Management User’s Guide for proper setup
		procedures.
	Improper console cable	Refer to Appendix A for proper console port
	pinouts.	pinouts.
	Corrupt firmware image,	If possible, attempt to download the image to
	or hardware fault.	the 2H258-17R again. Refer to Section B for
		instructions to clear NVRAM.
Cannot navigate	Improper Community	1. Refer to the SmartSwitch Series 2E253,
beyond Password	Names Table.	2H252, 2H253, and 2H258 Local
screen.		Management User’s Guide for Community
		Names Table setup.

2. If you have forgotten the Community Names, refer to Appendix B for instructions on how to set the mode switch to reset the Community Names to their default values.

Troubleshooting 4-5