Enterasys Networks 2200 manual Device Specifications, Physical Properties

Page 47

A

Specifications

This appendix provides operating specifications for the Enterasys Networks 2H258-17R. Enterasys Networks reserves the right to change these specifications at any time without notice.

A.1 DEVICE SPECIFICATIONS

Processors:

Intel i960 RISC processor

 

Power PC

Dynamic Random Access

 

Memory (DRAM):

20 MB expandable to 32 MB

FLASH Memory:

8 MB

Shared Memory:

4 MB

A.2 PHYSICAL PROPERTIES

Dimensions:

7.11H x 43.18W x 46.99D (cm)

 

2.8H x 17W x 18.5D (in.)

Approximate Weight (Unit):

8.18 kg (18 lb)

MTBF (Predicted):

200,000 hours

Specifications A-1

Image 47
Contents 2H258-17R SmartSwitch Installation User’s Guide Page FCC Notice Class a ITE Notice Bsmi EMC Statement Taiwan Industry Canada NoticeVcci Notice You and Enterasys agree as follows Enterasys NETWORKS, INC Program License AgreementPage Page Declaration of Conformity Contents Troubleshooting Figures Tables Structure of this Guide Using this GuideAbout This Guide Related Documents This guide uses the following conventions Document ConventionsPage Overview IntroductionRuntime IP Address Discovery ConnectivityRemote Monitoring Rmon Full Duplex Switched EthernetSmartTrunk Traffic Rate Limiting Broadcast SuppressionPort/VLAN Redirect Functions 11 802.1 Port Priority Garp Switch OperationFlow Control Standards Compatibility Switching OptionsManagement Optional HSIMs and VHSIMsGetting Help Lanview Diagnostic LEDsPage 100BASE-FX Network Network RequirementsPage Installation Unpacking the Device Installing OptionsTabletop or Shelf Installation Installing the DeviceGuidelines for the Rackmount Installation Rackmount InstallationStrain-Relief Bracket Screws Rack Mounting the 2H258-17R Installing the Device in a Rack Connecting PowerRedundant Primary AC outlets are On separate circuits Connecting to the NetworkConnecting to the Network Fiber Optic Connection Completing the Installation Page Using Lanview TroubleshootingPWR CPU OFF Troubleshooting ChecklistRefer to the SmartSwitch Series 2E253 2E253, 2H252, 2H253, and 2H258 Local User parameters Reset Button Using the Reset ButtonPhysical Properties SpecificationsDevice Specifications INPUT/OUTPUT Ports Electrical SpecificationsEnvironmental Requirements Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank SettingsRemoving the Chassis Cover Optional Installations and Mode Switch Bank Settings B-3 Figure B-1 Removing the Chassis Cover Figure B-2 Mode Switch Location Setting the Mode Switches6Optional Installations and Mode Switch Bank Settings Locating SIMMs Simm UpgradeInstalling the Dram Simm Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics IndexIndex-2