Enterasys Networks 2200 manual User parameters

Troubleshooting Checklist

Table 4-2 Troubleshooting Checklist (Continued)

Problem Possible Cause Recommended Action

User parameters	1. Position of Mode switch
(IP address,	(7), NVRAM Reset, was
Device and	changed sometime before
Module name,	either cycling power or
etc.) were lost	pressing the RESET
when the	button, causing the
2H258-17R	user-entered parameters to
power was cycled	reset to factory default
or the front panel	settings.
RESET button	2. Clear NVRAM was set
was pressed.
	through Local
	Management.

1.Reenter the lost parameters as necessary. Refer to SmartSwitch Series 2E253, 2H252, 2H253, and 2H258 Local Management User’s Guide for the instructions to configure the device through Local Management.

2.If the problem continues, contact Enterasys Networks for assistance.

Troubleshooting 4-7