Aiwa NSX-A508 Inserting Blank Spaces, Insert the tape to be recorded on into deck, Engl/Sh I

This section explains how to record from the tuner, CD player, or external equipment.

Preparation

●Use Type I (normal) tapes only.

●Set the tape to the point where recording will start.

●Note that recording is done on only one side of the tape

,-, ,.! ,. ..,, ,. .,.. ,,. ,,. ,,,

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables you to activate the

Music Sensor function, (Applicable when the source is TUNER,

VIDEO/AUX or MD.)

1Press ‘@ REC/REC MUTE during recording or while in recording pause mode.

~ on the display flashes for4 seconds and 4-second blank space is made. Then, the deck enters the recording pause mode.

2Press II to resume recording.

To insert a blank space of less than 4 seconds, press @

REC/REC MUTE again while ~ is flashing.

To insert blank s~aces of more than 4 seconds, after the deck enters recording pause mode, press @ REC/REC MUTE again. Each time the button is pressed, a 4-second blank space is

added

About cassette tapes

*To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool.

.:

;Z :;$

,,

x-

.-m:

-g

●

‘~

‘“E

::f,+;

~

‘~

1 Insert the tape to be recorded on into deck 2.

Insertthe tape with the side to be recorded on first facing out from the unit.

\

\

*

2 Press function (CD, TUNER, VIDEO/AUX or MD) and prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).

To record from a radio broadcast, press TUNER and tune

in to a station.

To record from a connected source, press VIDEO/AUX or

MD,

3 Press @ REC/REC MUTE to start recording.

When the selected function is CD, playback and recording start simultaneously.

When recording from a connected source, start playback of the source.

To stop recording, press 9.

To pause recording, press II. (Applicable when the source is TUNER, VIDEO/AUX or MD) To resume recording, press it again.

Sound adjustment during recording

The output volume and tone (except BBE) of the speakers or headphones are freely varied without affecting the level of the recording.

Side A ab for side A

To record on the tape again, cover the tab openings with adhesive tape, etc.

*120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended.

●Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism.

-,

To erase a recording

Make sure the microphone is not connected to this unit.

1Insert the tape to be erased into deck 2 and press TAPE DECK 1/2 to display ‘(TP 2“.

2Set the tape to the point where the erasure is to be started.

3Press @ REC/REC MUTE to start the erasure.

ENGL/SH I 2