Aiwa NSX-A508 manual Vocal FADER/MU-LTIPLEX Functions #, Connect your microphone to the MIC jack

,,, ,. .,..,,, ,-.

VOCAL FADER/MU-LTIPLEX FUNCTIONS #

;,’J:

This unit can use discs or tapes as Karaoke sources.

Use the vocal fader function for ordinary discs or tapes,

E’

g;

1

A microphone (not supplied) can be connected to this unit, allowing you to sing along to music sources,

Use a microphone with mini plugs (03,5 mm, 1/8 inch).

1 Connect your microphone to the MIC jack.

MIC 1

2 Press one of function to select the source to be mixed, and play the source.

3 Adjust the volume and tone of the source.

4 Turn the MIC VOLUME control to adjust the microphone volume.

To record microphone sound mixed with source sound

Follow the procedure for recording from the sound source (see page 12).

SYNCHRO DUBBING cannot be used for mixing recording.

When not using the microphone

Set the microphone volume to MIN and remove the microphone from the MIC jack.

*If a microphone is held too near the speakers, a howling sound

may be produced. In this case, hold the microphone away

from the speakers, or decrease the microphone volume.

●[f sound through the microphone is extremely loud, it may be distorted, In this case, decrease the microphone volume.

Recommended microphone

The use of unidirectional type microphone is recommended to prevent howling, Contact your local Aiwa dealer for details,

Use the multiplex function for multi audio discs or tapes,

‘1!

Press KARAC)KE repeatedly to select the vocal fader or multiplex function.

I (Q @ I

@Vocal Fader

The singer’s voice becomes softer than the accompaniment.

@Auto Vocal Fader

The singer’s voice becomes softer only while there is audio input through a microphone.

@Multiplex

The sound on the left channel is heard from both speaker:; and the sound on the right channel is muted.

To hear the sound on the right channel, see below,

@Auto Multiplex

The sound on the left channel is heard from both speakers, ❑ and the sound on the right channel is muted only while there

is audio input through a microphone.

To hear the sound on the right channel, see below.

@Cancel

To change the time lag setting in Auto Vocal Fader olr

Auto Multiplex function

The muted original singer’s voice can be turned faster to the normal level.

When Auto Vocal Fader or Auto Multiplex is selected, “A-W” or “A-MPX is displayed for 3 seconds and changes to the selected function name. After the selected function name is displayed, kee~ pressing KARAOKE until “FAST”is displayed.

To return to the initial setting, select SLOW.

When the power is turned off, SLOW is restored.

To change the audible channel in Multiplex function

When Multiplex is selected, “MPX -L” is displayed for 3 seconds and changes to the selected function name. After the selectec~ function name is displayed, kee~ ~ressinq KARAOKE until “MPX- R“is displayed.

To return to the initial setting, select MPX-L,

When the power is turned off, MPX-L is restored,

●The Karaoke functions may not operate correctly with the following kinds of CDs or tapes,

-Those with monaural sound

-Those recorded with strong echoes

-Those with the vocal part recorded on the right or left side of the sound width

●While the Karaoke function is on, the sound is output as monaural.

●When the function is changed, the Karaoke function is canceled,

i3fGL/SH 16