Aiwa NSX-A508 Press CLOCK, then press II SET within, Seconds, Press Sleep while pressing Shift

1

,—.-

			--du
1 Press CLOCK, then press II SET within 4	The	unit	can be turned off automatically at a specified time,
seconds.	Use	the	remote control,
	1 Press SLEEP while pressing SHIFT.

When using the remote control

Press CLOCK while pressing SHIFT, then press II SET- 4 seconds,

2 Press -44 DOWN or - UP to designate the hour, then press 11 SET.

The hour stops flashing and the minute starts flashing,

3 Press -d< DOWN or > UP to designate the minute, then press 11 SET.

The minulestopsflashingon the displayand the clockstarts

from 00 seconds,

To display the current time

Press CLOCK. The time is displayed for 4 seconds, However, the time cannot be displayed during recording,

To switch to the 24-hour standard

Press the CLOCK and then press ❑ within 4 seconds, Repeat the same procedure to restore the 12-hour standard.

This is caused by a power interruption. The current time needs

~’If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

‘ENTER is ako avai/ab/e instead of II SET.

* MULTI JOG is also available instead of 44 and W.

2 Within 4 seconds, press + or > to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off Press SLEEP once while pressing SHIFT. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that “SLEEP oFF” appears on the display,

‘ MULTI JO,G is also available instead of M and W.

ENGLISH 18