User Guide | WireSpeed Dual Connect NAT Router | |
|
|
|
| defined by the Router. A connection profile is information that the Router needs | |
| to establish a connection to your ISP. The “PPP Status” columns will show a |
|
| status of “UP” if the Router is currently using that profile to communicate. The |
|
| command button allows you to control the connection state. |
|
Profile Editor | Selecting the “Profile Editor” link will allow you to define or change any of the |
|
| connection profile settings. |
|
L
LAN Configuration
This screen contains the setting that controls how the Router interacts with the local devices connected to the Router. Westell does not recommend that you change these settings. The following settings are displayed.
| LAN Configuration |
Router IP Address | This controls the IP address that the Router uses for local communication. |
Subnet Mask | This setting specifies the subnet mask to use to determine if an IP address |
| belongs to your local network. |
DHCP Start Address | This setting specifies the start of the IP address pool that the Router uses to |
| assign IP addresses to local devices. |
DHCP End Address | This setting specifies the end address of the IP address pool used for automatic |
| configuration of local devices. |
DNS Server Enable | DNS stands for Domain Name System. This is an Internet standard that |
| facilitates communication among devices. This allows a name to be used when |
| specifying a device instead of an IP address. Normally you want this enabled. |
DHCP Server Enable | DHCP stands for Dynamic Host Configuration Protocol. This is an Internet |
| standard that allows the Router to automatically assign IP addresses to devices |
| connected on the LAN network. It is advised that this option is set to Enabled. |
LAN Statistics
This page contains information regarding the configuration and status of your Local LAN. The following settings are displayed.
|
| LAN Configuration |
|
|
| Device IP Address | This displays the IP address that the ADSL router uses for local communication. |
| |
| DHCP NetMask | This displays the subnet address that the ADSL router’s DHCP server issues in |
| |
|
| DHCP responses. |
|
|
| DHCP Start Address | This setting specifies the start of the IP address pool that the modem uses to |
|
|
|
| assign IP addresses to local devices. |
|
|
| DHCP End Address | This setting specifies the end address of the IP address pool used for automatic |
| |
|
| configuration of local devices. |
|
|
| DHCP Server Status | Displays the status, “ON” or “OFF” of the DHCP Server |
|
|
| DHCP Server | Displays which network “Public” or “Private” the DHCP server is serving IP |
|
|
|
| addresses for. |
|
|
| Devices on LAN | This page displays the current devices the modem has found on your LAN. The |
| |
|
| name of the device, the Ethernet MAC address, and the status, “Active” or |
|
|
|
| “Inactive” is displayed in the table. |
|
|
|
|
|
|
|
|
| 104 | March 2003 |