Westell Technologies 2100 manual Router Installation via 10/100 Base-T Ethernet

User Guide WireSpeed Dual Connect NAT Router

NOTE: If you are using a Westell Dual Connect Router in conjunction with an Ethernet Hub or Switch, refer to the manufacturer’s instructions for proper installation and configuration. Westell recommends the use of a surge suppressor to protect equipment attached to the AC power supply.

5.4.1 Router Installation via 10/100 Base-T Ethernet

NOTE: Before you connect the Dual Connect Router via 10/100 Base-T, you must have an available

!Ethernet card installed in your computer. If your Ethernet card does not auto-negotiate, you must set it to half duplex. Refer to the Ethernet card manufacturer’s instructions for installing and configuring your Ethernet card. If you do not have an Ethernet card installed in your computer, go to section 5.4.2.

~

1.Connect the power supply cord to the power connector marked 12V on the rear panel of the Router. Plug the other end of the power supply cord into a surge-protected AC wall socket.

2.Connect the DSL phone cable from the jack on the rear panel of the Router marked to the DSL-equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the phone cord that was provided with the Router kit.

3.Connect the Ethernet cable from the Ethernet jack markedon the rear panel of the Router to the Ethernet port on your computer.

Congratulations! You have completed the Ethernet hardware installation for your Dual Connect Router. No software installation is required when using an Ethernet connection. Refer to your Internet Service Provider’s instructions for installing subscriber software and connecting to the Internet. You must now go to section 7.

Figure 1. Connection via 10/100 Base-T Ethernet

030-300198 Rev. D 6 March 2003